(800) 853-2651
SHOP NOW

Recent content by TRA1691

Yesterday's Tractor Forums
  1. nashranch

    Fuel Shutoff Valve

    Today I pulled the gas tank on my 640 to try and repair the leaking fuel shutoff. I drilled out the pin holding the brass shutoff screw in. Tapped the hole 8-32 and used a brass screw in the tapped hole. Of course I replaced the o-ring in there. Put it all back together and no leaks.
  2. G

    styled ar hydralics

    I just purchased hydraulic tower for my 51 ar and need to know where hydraulic lines to reservoir tie in to chasis as no piping with it. I'm guessing will need to install a pump in transmission rear end housing that drives off pto shaft. Thanks for your help. Paul
  3. D

    Ford 4000 PTO quits

    Ford 4000 PTO stops after Bush hogging a little while, let set a few minutes will work again for a little while
  4. A

    Farmall 706 diesel with low compression on # 2 3

    Finally got around yesterday to check the compression on a Farmall 706 diesel with the earlier International 282 diesel glow plug engine. The tractor had lost a lot of power, smoked somewhat, and made sort of a big air compressor type noise which was pretty loud when the air filter was taken...
  5. L

    Massey 1100 PTO clutch

    I have an 1100 that the PTO does not work correctly on. The PTO will turn, until it gets a load on it, then it stops, would that be worn clutches or something else? Everything else like steering and brakes are working. It worked until the coupling to the front pump went out, I fixed that but the...
  6. F

    ford 7000

    have 7000 power steering ? oil seeping out of weep hole on steering body that is right under instrument panel any ideas on repairs
  7. B

    Kuhn Tedder; need help with set up and use

    I purchased a (later) Kuhn tedder and it needs more work than I realized. I'm also trying to figure out how to use it because there is such little for resources. I can't believe Kuhn is such a big brand with so little information on functions and features. This is a 6 basket tedder, manually...
  8. T

    D14b Lubricants

    I just picked up my first old tractor, a 1958 D14 (gas engine). It runs great but I don't have records when the last maintainance was done so I would like to start out by new lubricants in it from front to back. I have the original oqwners manual and the suggested fluid and capacities but I...
  9. T

    D14 with Model 150 Loader

    Thank you I'll give it a shot
  10. T

    D14 with Model 150 Loader

    Can anybody gve me a source for a set of hydraulic ram seals for a model 150 loader on a D14?
  11. T

    D14 Value

    Unfortunately I am also the seller. I am one of the direct beneficiaries and we all just offered to let each other buy anything we might want before anything is auctioned. We argeed to buy things rather than give them away between us so that everybody gets a piece of everything. We agreed to...
  12. T

    D14 Value

    I have an opportunity to buy a 1958 D14 that I grew up with from my Grampa's estate. It runs well. The engine was rebuilt about 20 years ago. It probably hasn't had more than 25 hrs per year put on it for the last 15 years. It has a factory loader, 3 pt blade and 60' brush mower all 30+ years...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top