(800) 853-2651
SHOP NOW

Recent content by tracto4

Yesterday's Tractor Forums
  1. T
    Expired

    For sale Tufline Subsoiler two Shank 2S2480

    Only used a few times. almost new condition.
    $2,500.00
  2. T

    Case 885N tachometer cable

    Trying to find a replacement tachometer cable for an 885N tractor. Spec says it should be PN K954955. Purchased one, but connector doesn't fit on engine side. Anyone have such a problem and how to resolve? Thanks
  3. T

    Case 885N water temperature sensor,, coolant leak

    THANK YOU! You are correct. The leak was at the newly installed temp sender, not the water pump seal. Saved me a big job...
  4. T

    885 water pump seal

    I know your post was a couple of years ago. How did the installation work out? Any advice as I'm going to attempt this job next week. Thanks
  5. T

    Case 885N water temperature sensor,, coolant leak

    Yes my sender does have parallel thread and a taper. My original sender , disconnected on the left, is of a really small size diameter compared to the replacement. I couldn't find a direct replacement for it. I just hope using the hole on the right didn't somehow cause my water pump seal on...
  6. T

    885 water pump seal

    I'm getting ready to replace the water pump on my 885. Did you have to remove the radiator to remove the pump? How did you end up sealing the leak on top of the pump? Thanks
  7. T

    885 water pump seal

    I just saw one of your posts from a couple of years ago. Regarding the installation of the rubber seal on top of the water pump. Is there a special way these need to be installed so they don't leak? Do I just put some rtv top and bottom of the seal and push the pump up to enable bolts to be...
  8. T

    Case 885N water temperature sensor,, coolant leak

    Here is the after picture
  9. T

    Case 885N water temperature sensor,, coolant leak

    My early 1980 885N has a bad water temperature sensor. Sender is on the left with a plug on the right. Only replacement sensor available is of a larger diameter than the existing one. But the new sensor does fit into the plug opening on the right. So, I removed the plug and installed it there...
  10. T

    Massey Harris 50 Loader 1957

    Thanks for the reply. My MH50 loader has its bell shaped breather on the left mount along with the controls. There is no " dipstick" in that assembly. I do see a tank on the lower part of that left mount where I presume the filter is. I just don't know how to check for the proper amoumt of...
  11. T

    Massey Harris 50 Loader 1957

    Looking for some advice... I've got a 1957 MH50 Loader . The tag on the loader shows model number as 202, made by Mid-Western Industries. I just got this tractor and want to check / fill the loaders' Hydraulic oil. I'm ok with the engine, P/S, and trans. oils. Can anyone tell me where the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top