(800) 853-2651
SHOP NOW

Recent content by TractorJohn

Yesterday's Tractor Forums
  1. T

    zinc oil additive

    Yes or just use Valvoline VR1 10w-30 racing oil. The VR1 in the gray bottle is regular motor oil not a synthetic. It's still in on road oil but in reduced amounts to protect converters. Regular VR1 Racing Oil •High zinc/phosphorus provides extreme wear protection, including flat tappet...
  2. T

    D 17 thermostat housing

    I was going to mention stainless steel bolts but I didn't want to get all the part time scientists on here writing term papers on galvanic corrosion. So since you mentioned it it's going to be your fault not mine if they do. LOL
  3. T

    D 17 thermostat housing

    If you get them out use Never Seez on the new ones. Put the right size screw driver in the slot and give the screw driver some firm hits with a hammer. Vibration helps free rusted bolts.
  4. T

    D 17 thermostat housing

    There were different ones for the diesel engine but the gas engine used the same housing and cover on all four series. The housing fastens down with two nuts on studs and the cover bolts together. You could probably use regular bolts if your worried about the slotted ones.
  5. T

    D 17 cuts off when worling on bank

    Mine does that when it's low on gas. Gas runs to the other side of the tank leaving the outlet side of the gas tank dry.
  6. T

    Starter MF 65

    The 6 volt starter will work fine on 12 volts as long as you don't over do it when cranking it. If the tractor starts right up with a few turns it will be ok. Go to the AGCO Online Parts Books and compare starter numbers for the other models. Parts Books
  7. T

    Aliis Chalmers B Engine Noise

    I hate to hear that kind of noise coming from a engine. I would guess a rod bearing or a main bearing.
  8. T

    amp meter on a TO 30

    Does the needle ever move? Ammeter may be bad.
  9. T

    Odd B, haven't seen one of these

    I made a link for you. Never heard of one. It looks like a D270 but I could be wrong. Link
  10. T

    Allis WC

    Get # 1 cylinder at TDC on a compression stroke and then look at the rotor. It will be at the # 1 plug wire spot and then go from there clockwise.
  11. T

    o/t gas price//from past thread

    Good Job!!! Glad you didn't drive 11 miles for 10 cents cheaper,that would of been stupid. But there are people that would and feel good about it.
  12. T

    Answer to your question

    I don't even remember making a post.
  13. T

    Ferguson engine oil

    Send me an email for some engine oil info. [email protected]
  14. T

    Answer to your question

    Well since this original post has no tractor related theme like this section is suppose to have I figured nobody would really care if I didn't really pay attention to the question either and it was late when I posted it and I was drunk.
  15. T

    Answer to your question

    This question was asked. Quick Yes or No question. With gas prices as high as they are would you drive 10 miles out the way (5 miles there and 5 miles back) to save $.10 per gallon???????? No. But it depends on how many miles to the gallon you are getting. The average fill-up is 15...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top