Recent content by trainv

  1. T

    Ferguson TEA20 running bad, backfiring, wont rev up.help

    unless you have ghosts, it was running fine when you parked it my opinion I would start with fuel electrical does go bad sitting could be a stuck valve
  2. T

    Valve spring retainer

    If you think parts are too expensive for these old tractors, then you took up the wrong hobby.
  3. T

    V-belt

    I believe that using the stock generator pulley with either the generator or an altenator a NAPA 28806 or a 5L390 belt will be the one you need.
  4. T

    Wiring

    Buy a 12 volt coil with a built in resistor.
  5. T

    Wiring

    I believe 12 volts to your points will burn them up very fast.
  6. T

    TO-30 belt

    napa number is 2528406 cheaper from this site
  7. T

    IH 606 hydraulics

    I failed to mention that 3 point also works fine. As I look at the IT manual I see that this tractor only has 1 pump which is ran off the gear on the left side of the tractor and filters and screen are on the right side. Thanks Todd
  8. T

    IH 606 hydraulics

    Started my 606 last week in the below zero weather, let it run for a few minutes and then tried to lift the loader, it moved about 2 in and that's it. I have power steering and pto but no loader hydraulic pressures any ideas?
  9. T

    Davis Loader pump

    look on this site in parts for TO 35, hydraulics section, bottom of the page I believe what you are looking for is a #192169
  10. T

    to 30 oil tube

    Hi All My oil fill tube leaks around where it fit into the block. I have tried silicone but that doesn't seem to hold it. Has anyone else had this problem and what have you done to fix it Thanks todd
  11. T

    clutch pedal adjustment

    Hi all I am adjusting the dual disc clutch on my 135 and can't not keep the pedal from turning on the throw out bearing shaft. Has anyone ever had this problem and came up with a fix? Thanks Todd
  12. T

    Is my charging system working?

    not a fan of removing a cable while machine is running to check charging system!~! can damage components. check battery voltage with engine off with meter, then start machine and check it again, if working, voltage should go up , depending what state the battery is, maybe up as far as 7.5...
  13. T

    Aussie slasher setup refining

    Thank You!! it is nice to see what equipment is called around other parts of the world!!
  14. T

    Aussie slasher setup refining

    pictures of your slasher?
  15. T

    TO35 Ferguson Changing Transmission and Hydraulic oil

    One place to be sure to check is shifter boots. If they are cracked or missing and not in good shape, water will leak into your transmission.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top