Recent content by Treeman22

  1. T

    Thermostat won't work

    Attached are some photos of the thermostat housing for my Oliver 60. There is a smaller hole in the engine block shown in the first photo. However there is no hole in the thermostat housing. I am assuming the smaller hole is for coolant circulation. I also noticed the thermostat I got will...
  2. T

    Oliver 60 heating up

    I went out and put my temp gauge through rigorous testing. I pulled the temp sensor out and heated water in a can to various temperatures. I used a kitchen thermometer to take temps on the water. The gauge moved starting at 170, at 180 it hit work range, at boiling it hit the hot range. So the...
  3. T

    Oliver 60 heating up

    The gauge has the the yellow background and reads cold work hot the colors on that are blue green and red. I believe it's the original type. But it was new when I put it on
  4. T

    Oliver 60 heating up

    I filled tractor with water and ran until hot, opened the drains and flushed both directions several times. I filled with water again and ran it for about an hour and drove it around. The temp gauge never budged off of the lower end of the cold. It didn't seem to overheat. Which is good. I was...
  5. T

    Oliver 60 heating up

    I have it ordered. I will put it in after all of the flushing and cleaning is complete. Thank you for asking.
  6. T

    Oliver 60 heating up

    Thank you I will do this! I plan to run some vinegar through it as well.
  7. T

    Oliver 60 heating up

    Update, my brother came to the house and we tested the water pump. Took the top radiator hose off and cranked the engine over. Lots of water pumped out. So the water pump works. After that I drained the entire coolant system out and removed the block drain plug. I found quite a bit of rusty...
  8. T

    Oliver 60 heating up

    Thank you. I have not opened the block drain. I will do that and flush it out very good. I appreciate the feedback!
  9. T

    Oliver 60 heating up

    Maybe this question sounds silly but, is it possible that I need to run a power wire to the temperature gauge? Maybe that's why it's not working? Right now I have no power hooked to it.
  10. T

    Oliver 60 heating up

    Thank you! I will look into this.
  11. T

    Oliver 60 heating up

    Yes it has a recored Radiator and new water pump. Also the temp gauge is new but I have never seen the dial move on it. It didn't have a thermostat when I got it and I wasn't sure if it was supposed to have one or not. Would you have ideas on where I could order one? Thanks
  12. T

    Oliver 60 heating up

    I have an Oliver 60 I got running within the last couple years. It runs great! I'm proud of how good it runs considering I'm not necessarily a mechanic. Anyway, it starts right up runs great, but it seems to be heating up after it runs awhile. Antifreeze will run out of the overflow and the...
  13. T

    Oliver 60 muffler

    Ok thanks. Since they are supposed to go down inside the manifold, does it just sit in there or is there some way to fasten it in place? There are no holes in the manifold to bolt or screw the muffler in place and an exhaust clamp on the outside of the manifold would do nothing. Is it relying...
  14. T

    Oliver 60 muffler

    Thank you. If it is supposed to slide down on the outside of the manifold, why do the mufflers I am finding on the market say they are supposed to slide down inside the outlet on the manifold?
  15. T

    Oliver 60 muffler

    Could someone explain how the muffler is supposed to attach to the exhaust manifold on an Oliver 60 Row Crop? I need a new muffler as my tractor didn't have one when I got it. I did not get the muffler yet because I would like to know how it attaches before I order it. Thank you!
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top