(800) 853-2651
SHOP NOW

Recent content by trencherman

Yesterday's Tractor Forums
  1. T

    farmall c timing

    thanks for everyones help. I will give these options a try.
  2. T

    farmall c timing

    I have a 1950 farmall c and it is very slow to turn over. I have had the starter, battery and cables etc. checked are all are OK. I know that timing of the engine can have an effect on how the starter turns over the engine. My problem is that my owners manual shows how to time an engine that...
  3. T

    1655 hydraulics

    J. 217 653 1068
  4. T

    1655 hydraulics

    this is the sprayer pressure. Not sure how to check the hydraulic pressure. I believe the relief valve dumps at 2100 psi. When using this tractor with a hydraulic cylinder everything works fine so I am assuming the pressure is normal.
  5. T

    1655 hydraulics

    When spraying the pressure was running between 30 and 40 psi. the sprayer has a Hiniker controller which is set at 18 gpa. It kept that rate within a gallon or so. It automatically adjust the pressure and flow according to the speed I am running. When the booms were shutoff on the ends the...
  6. T

    1655 hydraulics

    Bought the neighbors sprayer with hydraulic pump. When trying to spray the hydraulics on my 1655 got VERY hot. The tractor and pump are open hydraulic systems. The tractor output is 14.6 gpm and the max for the hydraulic pump on the sprayer is 7. Obviously there is a lot of oil going thru...
  7. T

    1066 hydraulics

    Getting low pressure hydraulic light on 1066 when it warms up(chisel plowing). When you engage the torque it takes longer and longer to engage as it gets warmer. Steering is little hard also. When cold everything works fine. Suspect a relief valve in the MCV valve. Any ideas?? thanks
  8. T

    1066 hydraulics

    thanks for the replies. Looks like trying to isolate which area the metal is coming from is where to start. Will not be able to work on it for a few weeks
  9. T

    1066 hydraulics

    Hydraulics on 1066 slowed down. Checked fluid and it was OK. Took cover off of filter and the metal screen had metal particles on it and was blocking the fluid from going to the pump. Cleaned the screen and everything works. I suspect a wheel bearing is going out. Any ideas on where to start...
  10. T

    spark plugs for 656

    Used to have a 656 and when putting it under power(discing etc.) it would start to lose power and shut down. Wait a minute and go again for a round or two or maybe not make it across the field. Tried everything(coil,plugs, condensor,wires etc. etc.)to no avail. Talked to shop foreman at IH...
  11. T

    Holley distributor

    I have a 1655 gas with a Holley distributor. I was able to cross-reference the points to delco. Are there any other cross-references for the cap, rotor, condensor etc. I am tired of paying the dealer a price 10 times more than it should be or is there an easy way to replace the Holley with a...
  12. T

    IHC C fowling plugs

    thanks for all your replies. Looks like I should change brand of plug and double check the ignition. The engine has been overhauled so I don't think the problem is internal.
  13. T

    IHC C fowling plugs

    I have a 1950 C tractor that keeps fowling cylinders 3 and especially #4. They are black with soot. Cylinder 1 and 2 are OK. I have had the carb rebuilt, checked the oil bath air cleaner(even took the wire mesh out from around the air cleaner body. When it sits and idles a little black smoke is...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top