(800) 853-2651
SHOP NOW

Recent content by tusky

Yesterday's Tractor Forums
  1. T

    Have a friend that had a close call earlier this week.

    Yrs ago mother Deere had a campaign to install shields on the starters to keep this very thing from happening. Last I looked it still was active PIP. Deere once had safety display showing the dangers of bypass starting. I saw it at the major farm shows. Sounds like the mans son has removed...
  2. T

    The vultures are circling already!!! I am PO at some people.

    I doubt the truthfullness of much of this story. With that being said if you perform all the good deeds you claim to on this forum when do you have time to farm? You post here only to for the pats on the back and the ego stroking. Anyone performing these deeds from the heart would have no...
  3. T

    Young fellow update!!!

    You said in first post they pulled the hitch off grain cart but now you claim it not damaged too bad and useable as is. I call BS on this story also.
  4. T

    Electrical issues

    Your used ECM could have been 20 hours away from the 250 Hr trigger point. just thinking out loud here
  5. T

    Electrical issues

    Kobelco excavators will show the wrench symbol when its time for PM service. Once you service the unit you clear the code from the ECM and the symbol goes away until the next 250 hr PM is required. You sure thats not whats happening with your unit?
  6. T

    Need a wiring diagram

    No wiring schematic in front of me but there was a PIP program on those back around 2005 because of the wiring harness chaffing where it came thru the operators platform/cab and into the fuse box. It caused the fuses to blow including the trans circuit. Also was known to burn a few machines...
  7. T

    Fiat Allis Track Loader

    no trans release of any kind and I doube that you have a big enough tractor to shake it lose from the ground after that much time. why was it parked all those years ago? if wery much is wrong its just scrap iron and spend you money on a good running unit.
  8. T

    rear wheel weights

    lol. I tried that before posting and found nothing. Will try again! Thanks
  9. T

    rear wheel weights

    I have 2 rear wheel weights and not sure what they originally were for. The only number I can find on them is T9648B. Anyone here have a clue? Thanks.
  10. T

    Pictures Of An 8N Diesel

    Looks to be a Kubota diesel. Looks like a factory install and great workmanship.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top