Recent content by Twhite

  1. T

    Oliver 550 Diesel

    I have a question regarding my new to me 1958 Oliver 550 Diesel. On the intake side of head, directly opposite each injector there is a 4 piece plug assembly that I'm sure is more than just a "plug". Can someone explain the what and why of these for me. Thank you
  2. F

    International 460 Utility rear end

    I am looking at a 460 Utility. I know that the 460 Farmalls had bad rears in 1959 and that they were fixed and the serial plates had been marked. This one is a utility with the serial 2905 SY. Can anyone tell me if the utilities had the same rear issues as the farmalls?
  3. U

    Ford Jubilee 3 point doesn't move

    I was given a ford jubilee that hadn't run in over 16 years. Through lots of work over the last couple of months I got it running. The problem now is that whether the selector for the 3 point is in manual or draft mode, the 3 point doesn't move. It has the original vane pump (see picture)...
  4. B

    Ford 4000 Timing Question

    Looking for some guidance on how to make sure I did not skip a tooth on my cav pump gears. I have the pump removed and have read it is difficult but possible to skip teeth with these gears,so how do you check it to make sure that Didn't happen? So I see a dot on each gear,do I just need to...
  5. D

    revisit on the hydro 656 flexplate

    instead of splitting the tractor can i just take out the engine to replace this? wouldnt it be like a clutch swap? would sure be easier if it works like that, thanks for the input.
  6. A

    Replacing top bearing in a 56 foot portable auger

    The top bearing on the auger shaft gave way on my Westfield 8 inch auger which is about 56 feet long. Have it all apart and the new bearing bought. This is a traditional auger, PTO driven, with a drive shaft to the top and the two traditional sprockets with a roller chain. I am trying to set...
  7. M

    Who has a Rest-O-Ride?

    I'm adapting a Fordson pan seat to my 63 Ford 4000 with a Rest-O-Ride because I really like the look and it looks plenty comfortable. It has a modern seat on it right now which is neither of those. Just got the pan in. Looks like the only thing that's really different is the front clip on the...
  8. S

    Cummins engine rebuild

    Is finally making some headway.
  9. S

    Massey 300 Combine - should BOTH wheels spin in neutral?

    I've been putzing with an old MF 300 combine that's been sitting in a field for a few years. Had to make a puller to pull the clutch, man was it rusted inside. I've jacked up the combine so the wheels are off the ground. If I put it in neutral I can spin the left wheel by hand, but the...
  10. E

    Vintage chain saw

    I picked this up from the original owner today , He lived on a lake and used it for occasional trimming and clean up. It had not been used in ten years he claimed , runs perfect. I have Stihl's but like these vintage homelite's , taken care of they will last.
  11. I

    Ag Lime?

    I'm not sure if this is the place to ask this if not maybe someone will tell me where to go. I have about 10 tons of Ag Lime left over from my hay field and I was wondering if it will keep until next year to use it then?
  12. J

    Lift All cylinder kits

    Does anyone know where kits to rebuild Lift-all cylinders can be found for Farmall mounted cultivators?
  13. T

    706 front axle?

    Is the front adjustable axle the same on a 706 and 656? I mean would they interchange? I know the 706 is a larger frame tractor but the front axles looked to be the same from a quick inspection.
  14. P

    Rops for a 1310

    I would like to purchase a ROPS for a 1310 ford. All the ones i have been able to find each side comes together and anchors to the third link hitch behind the seat. This design does not give me a lot of confidence. I would like to find one the bolts on the the Axles. Can any one tell me where i...
  15. Kirk-NJ

    Serial number tag

    What can you tell me about this tag? <a href="https://imgur.com/a5TMVCQ"></a>
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top