-
T
How to wire a two post amp gauge?
Do I still leave the yellow wire threw the loop hooked up to the terminal block?/when installing the new two post gauge?- tylerjcater
- Post #1
- Forum: Ford
-
T
How to wire a two post amp gauge?
Hi I have a 52 8n(still 6 volt original system) and am wondering how to wire the new ammeter gauge the post read positive on left side negaty on the opposite side?? Thanks.- tylerjcater
- Thread
- Replies: 5
- Forum: Ford
-
T
rear brackets for Dearborn snow plow
This message is a reply to an archived post by 8NrWI on August 16, 2010 at 05:58:52. The original subject was "Re: rear brackets for Dearborn snow plow". I recently bought a plow and the a-frame. Im missing the front axle brackets and rear mounting brackets. Didnt know if you new where I could...- tylerjcater
- Thread
- Replies: 3
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy