-
T
IH 282 Oil Pressure Gauge
Hi, So last night I put the oil gauge in and started the motor and I had 0 oil pressure I turned the motor off so I don't think anything was hurt. Where should I start to figure out why I don't have any oil pressure? Thanks- Tyson D
- Post #1
- Forum: Tractor & Farm Talk
-
T
IH 282 Oil Pressure Gauge
Hi, I'm rebuilding an ih 282 diesel motor in a 706 and I was going to put an oil pressure gauge in instead of the low oil light. Could I put the gauge in where the low oil sensor goes on the left side of the block? Thanks- Tyson D
- Thread
- Replies: 7
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy