(800) 853-2651
SHOP NOW

Recent content by ugh

Yesterday's Tractor Forums
  1. U

    Massey Harris 333

    Thanks guys. I think I am starting to understand/see why some of the Masseys seem to be a little cheaper to buy, engine parts must be hard to come by and expensive
  2. U

    Massey Harris 333

    I am new to this forum, IH guy. I would like to know if the MH 333's were good tractors and what is the price range for one. I am looking at one, straight sheet metal fair to good tires, wide front end no 3 point and has been repainted few years back and the runs, have not heard it run yet...
  3. U

    cat 955L

    Might try iron peddlers in Monroe NC, just north east of Charlotte NC they deal in CAT parts and equipment pretty good folks to deal with. 955's are strong tuff machines they have a lot of break out power
  4. U

    CAT 951C track loader

    I have a 951C for sell. Right final drive housing cracked, bearing failure I guess. Otherwise tractor in good shape, engine, trans, body. Tracks 60-70 percent. New hydro pump, 4 in 1 bucket,worn. Tractor is located on some of my land in Amelia Virginia just south of Richmond. $3,000.00
  5. U

    M Flip-Up seat

    Watch eBay they are on there from time to tIme Jgh
  6. U

    Foot clutch

    Question: Where Case SC and DC tractors equipped with a foot clutch and live PTO produced in limited numbers or are they fairly commons. Thanks JGH
  7. U

    Voltage loss at the starter - Farmall M gas

    You might want to have the starter cked/rebuilt. A friend of mine had the same problem, we removed the starter and found the bearings and cone bushings bad. He had the starter rebuilted and everything is good now. Good luck
  8. U

    Voltage loss at the starter - Farmall M gas

    You might want to have the starter cked/rebuilt. A friend of mine had the same problem, we removed the starter and found the bearings and cone bushings bad. He had the starter rebuilted and everything is good now. Good luck
  9. U

    Farmall C (pics)

    Very nice !!
  10. U

    Fuel proof paint in a rattle can for carb.

    I use Seymour cast blast original and on the manifold I use cast blast original 1200 degree. It gives the appearance of old cast. I have had good luck with it
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top