(800) 853-2651
SHOP NOW

Recent content by volnerj

Yesterday's Tractor Forums
  1. V

    Crankshaft pulley nut on a C200 engine

    Anyone know what size socket fits the C200 crankshaft pulley nut?
  2. V

    IH Farmall 544 Firing problems

    I was able to fix the issue. I had a faulty electronic ignition. Went back to the points and the engine now fires. Thank you all for your input and suggestions.
  3. V

    IH Farmall 544 Firing problems

  4. V

    IH Farmall 544 Firing problems

    No way to get it upside down. It comes assembled you just replace the plate assembly and install the magnet; however I will call Petronix to see if they have had quality issues or defects. Thanks for the advice.
  5. V

    IH Farmall 544 Firing problems

    Yes. It's in time. Thank you,
  6. V

    IH Farmall 544 Firing problems

    The tractor was running and while mowing it started popping out the exhaust like it was out of time. It then stopped all together after I did a tune up. I then took out the distributor and cleaned it up and switched to electronic ignition. I also put in a hot coil(3.3 ohms). I now have fire...
  7. V

    IH Farmall 544 Firing problems

    Thank you for you reply. The rotor is tight on the shaft. There is no spring clip under the rotor. I have replaced the cap and rotor twice and they do match the original one taken off. I have had the distributor apart and put back together. I have removed the breaker plate. What you describe as...
  8. V

    IH Farmall 544 Firing problems

    Looking for some help or advice. I have a 544 Farmall with a C200 gas engine. I can not get the plugs to fire. I have lots of fire from the coil to the rotor. I have timed the engine but still no spark. I can take the cap off the distributor and line up the rotor to the contacts on the bottom of...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top