Recent content by W4 MCCORMICK

  1. W

    1941 W4 STARTER, WON'T ENGAGE THE FLYWHEEL

    thanks used red MN for your reply and suggestions to a better farmall site for my w4 restoration. yes, you are correct...i was testing w/a 6v battery and some jumper cables. i then hooked up w/a 12v battery on the bench and the pinion snapped to the end, lol starter almost rolled off the bench...
  2. W

    1941 W4 STARTER, WON'T ENGAGE THE FLYWHEEL

    i'm early stages on this restore. only had the tractor running from a crank start. so i just got done cleaning up the starter, was very dirty and greasy inside. cleaned brushes, armature, commutator, bearings looked good and had good fit, cleaned up the pinion/spring/bendix system and lightly...
  3. W

    FARMALL CLUTCH JOINT BOLT TORQUES

    THKS. THAT WOULD MAKE SENSE. MINE ONLY HAD LOCK WASHERS AND I INSTALLED W/NEW LOCKS AND SNUGGED THEM UP GOOD.
  4. W

    FARMALL CLUTCH JOINT BOLT TORQUES

    THANK-YOU ALL FOR YOUR TIME & HELP ! GOT THIS CLUTCH JOINT ALL TIGHTENED UP AND ON TO THE NEXT SECTION OF THIS W4 RESTORATION
  5. W

    FARMALL CLUTCH JOINT BOLT TORQUES

    thanks and good point !
  6. W

    FARMALL CLUTCH JOINT BOLT TORQUES

    thanks ! its kinda tight in there for a torq wrench
  7. W

    FARMALL CLUTCH JOINT BOLT TORQUES

    on the clutch joint in my W4 with new rubber washers and cups, whats the torq for the 7/16-20 nut? thanks !!
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top