Recent content by Warba

  1. W

    Vac case slleve

    I had a coolant leak on a Vac case that had been sitting for a long time. I had the head machined but he said it wasn"t too far off and it might have other problems. It looks like one of the sleeves might be up just a little bit. Can I try and knock it back in with a piece of wood or would it be...
  2. W

    VAC case head gasket

    There was antiifreeze in the oil and it was throwing out antifreeze when running. I took the head off and it and the gasket look OK. There was a lot of scale in the water passages, plugging up the block drain. I blew a lot of it out and ran hot water through until it ran clear. The water stays...
  3. W

    Vac case cracked block ?

    I have a Vac Case that had been sitting for a number of years. I did get it running and then it after a little bit it started throwing out antifreeze. It was not overheated. I drained the antifreeze and there was some oil in it. I took off the head and I could not see any breaks in the head...
  4. W

    Antifreeze in oil VAC case

    First 2 numbers are 51 so it is a 1947. Thanks
  5. W

    Antifreeze in oil VAC case

    That is what I'm going to do. I was looking at a few posts and they are talking about sleeve o ring seals and maybe heads that go bad after sitting. I got some 10/30 Pennz and I'll buy a new oil filter and give it a shot. I'm going to start it with the radiator cap off and see if there is any...
  6. W

    Antifreeze in oil VAC case

    I am trying to get a Vac Case that has been sitting out side for 8 years. A small amount of green came out first when I took out the oil drain plug. I know its possible the block is cracked or a bad head gasket. Is there any possibility things will be OK if I fire it up. Northern MN
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top