-
W
Ferguson TE20 - converted to 12V with a generator?
Funny you should say that Steve - part of the reason I got a good deal on this machine is that there are several stripped spots on the ring gear, and as a result it doesn't reliably start depending on where in the rotation the engine stops. The previous owner didn't have the ability to split it...- Waudby
- Post #6
- Forum: Harry Ferguson
-
W
Starter not engaging.
I've had this issue in the past, and I've always been able to fix it by cleaning up the contacts on the starter switch. The cover of the switch where the two posts come out of can be removed. Remove the three screws holding it down. There is a spring inside that may push the cover up as you undo...- Waudby
- Post #3
- Forum: Harry Ferguson
-
W
Ferguson TE20 - converted to 12V with a generator?
Hey folks, I have acquired a pretty straight TE20 that needs rewiring among a couple other things. The wiring is pretty cobbled together. I have rewired a TEA20 before (12V one-wire alt) so it's familiar enough erritory. However, this one has some things going on that are unusual to me...- Waudby
- Thread
- Replies: 9
- Forum: Harry Ferguson
-
W
TEA 20 Tappet Cover Vent Tube
Thanks folks, I will see about Silver Fox spares. Also I think Charles might be correct that one from scrap might be easiest. There is a large agricultural equipment scrapper in southern Ontario that I will check out. One thought though since Bob has confirmed the thread size on the rocker...- Waudby
- Post #1
- Forum: Harry Ferguson
-
W
TEA 20 Tappet Cover Vent Tube
Thanks Bob, appreciate any help. I'm in Ontario, Canada. Charles, thanks for the clarification on the "jiggle pin" (technical term?). I'm optimistic that I can either make one with some off the shelf parts or else source one. Maybe I'm looking in the wrong places, but it seems surprising to...- Waudby
- Post #1
- Forum: Harry Ferguson
-
W
TEA 20 Tappet Cover Vent Tube
Hello, I have a bit of a basket-case TEA 20 that I've got to a decent running condition. I am trying to replace the missing re-circulation tube that runs from the top of the tappet (rocker) cover to the intake manifold. I understand this can cause idle issues (which it seems to be), but also...- Waudby
- Thread
- Replies: 15
- Forum: Harry Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy