(800) 853-2651
SHOP NOW

Recent content by Wayn_h

Yesterday's Tractor Forums
  1. W

    newest addition

    Wow! That is great. I remember passing tractor safety more than a few years ago, my reward was getting my job on the farm back! And I was happy for less than a dollar an hour! Wayne
  2. W

    JD 7210 overheating

    get an IR thermometer and measure the temperature of the inlet and outlet house of the radiator and the engine. Home Cheapo sells them, and they are on line a dime a dozen. Wayne
  3. W

    Airplane Fuel?

    Buickanddeere had it right... There is no ethanol in the avation gas, so the gumming problems we all have using regular gas will go away. I'm buying it now for my small engines that use gasoline and putting it in them as the last fill up of the year. I still add marine grade stabil. Alcohol...
  4. W

    JD 60 clutch sticks

    Is the clutch bearing siezed?
  5. W

    48 B clutch hanging

    Well, I had it apart today and seemed to fix it. This should have been an easy job, but the two bolt holes in the clutch drive disc were stripped, so I had to drill/heli-coil them to take the drive disc off. Actually, everything looked pretty good inside, includng the clutch dogs, operating...
  6. W

    48 B clutch hanging

    OK, before I get yelled at, I do have the service and parts manual, and I just looked at how to get at the bearing. It looks pretty simple, and I can make up a puller if needed. What about this bushing that is also on the pulley on the side close to the housing? Does that hang up and go bad...
  7. W

    48 B clutch hanging

    Everyone: OK, thanks for the replies. Sounds like I better look at the bearing in the pulley. Yes, I always start it in neutral, and that is how I realized I had a problem. Can anyone give me any hints on how much this is? Pull the pulley cover, remove the plates, is it obvious where the...
  8. W

    48 B clutch hanging

    I have a 48 B that I've had now since '04 and it has been a great machine with no issues. The last two time I went to use it, the clutch would not "release" when in neutral, the belt pulley kept spinning? I don't see the problem at all when it is in gear though, and it does not seem to drag when...
  9. W

    '88 F350 with 7.3 non turbo diesel...

    So I still have my 88 F-250 with 7.3 IDI non-turbo on the road. It runs great. One possible problem that is hard to detect is damage from cylinder cavitation caused by failure to maintain the cooling system properly. Not the fault of the owners, Ford sent out warnings to people in the late 90's...
  10. W

    Shifter Problem on JD '52 A

    I have a 48 B and assume the the transmissions work the same... So mine did the same thing... I pulled the top plate off the trans and tightend the square head bolt that holds the shifter fork in place. Don't ask me what that is called, but the problem was obvious when I took a look. Wayne
  11. W

    OT-internet signal question

    yes, especially if you do not have "encryption" turned on, such as WEP or WAP. On my Linksys you can log into the router (you need the username and password), go to the "status" section, click local network and then click DHCP table and look aat the users. Email me if you need more...
  12. W

    1945 (hand start) Model A Serial #554698

    I replaced my lining and did not want the clip on one since it looked wrong. My dealer (Gardiner in Waldorf MD) picked up the right part and it came with the rivets. I bought the rivet tool from somebody on two cylinder magazine. Mr. Gardiner is a collector himself, and probably spent more time...
  13. W

    3020 Diesel Running hot I am not sure???????

    Some of the guess's people have are crazy. Without measuring the actual temp, nobody has a clue what is going on. Get at least an IR probe. My "GUESS" is that you are fine with no problem. (well, it ain't boining over is it!) but without numbers to back you up we're all just typing for the fun...
  14. W

    Pics From My Travels In Central NY Today

    Would be nice to see picture in the summer too, just catching that two week window can be tricky..... Wayne
  15. W

    Cold weather diesel question

    My 23 year old Ford (actually IH-7.3) has a heater in the fuel pump to avoid that. Below freezing it turns on. Also, if water is in the bottom of the tanks, the way the fuel pick up works it will start sucking fuel up part way up the pick up tube. Ask me why I know all this... Wayne
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top