Recent content by Willard Schlesener

  1. W

    John Deere 70 starter

    Brother-in-law's JD 50 had the same problem. Sent the starter out for repairs and the problem was the fields were bad. The rebuilder replaced the fields, bushings, starter switch and brushes. Works like a new one.
  2. W

    1947 John Deere A Rear Axle Hub

    See the posting dated 7-15-05 by JLG. There was an article in the Green magazine regarding the removal of the hub. I don't remember what month or year.
  3. W

    Plow Shears

    Do you have an email address or telephone number or an address where I can contact him? Thank You.
  4. W

    Plow Shears

    Plow Shears for model 14 plow. Does anybody know if the shears for the AO are the same?
  5. W

    Plow Shears

    Who sells replacement 14" PLOW SHEARS?
  6. W

    MF 135 fuel tank sending unit

    I ordered my replacement from Tractor Joe.
  7. W

    Ferguson14A moldboard plow

    What years did they make this model plow and for which model tractors?
  8. W

    Two cylinder tractor size

    We use to farm a section of ground with a Model A in Kansas.
  9. W

    Tractormeter

    Re-build or replace? Who supplies parts for this instrument? Mf 35 and the To-35 use the same Tractormeter? This is a MF35 Gas model tractor, 1961. Parts book list part number 751635 M91
  10. W

    Transmission drive shaft

    Thank You. I won't get into it till next month. There is a noise in the gear reduction area. When I replaced the bearings every gear looked ok. No un-usual wear pattern. The transmission shifts like it should and the clutch works perfectly. I replaced the bushing and bearing in the clutch...
  11. W

    Transmission drive shaft

    That bearing is supported by the reduction gear cover. It doesn't prevent that drive shaft from moving horizontally towards the transmission housing. All bearings have been replaced. I don't think that drive shaft is to move; if so the first reduction gear won't mesh correctly with the...
  12. W

    Transmission drive shaft

    Model 60 Is it normal for this shaft to move horizontally inside the reduction cover?
  13. W

    sliding rear tires on 1949 JD A

    I saw an article written in the green magazine on how to move the wheels on the axels and it worked! Remove the clamp that goes over the hub and install long all thread bolts in place of the cap screws. Next install the clamp over the all thread bolts and place the drawbar between the end of the...
  14. W

    tractormeter

    I have a 1961 MF 35 Deluxe Gas model.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top