-
W
Model B clutch bearing
You will have to remove the entire clutch. I had to slide the right wheel out on the axle to get enough clearance to remove clutch. When you get the clutch removed, lay it on table with gear facing up. Use something that is not sharp, go down through hole in bearing, and drive out the...- windrow12
- Post #1
- Forum: John Deere
-
W
41 B Knocking from Clutch
Mike, I have replaced the clutch driver disk on my 41 B. I have tried brass shim stock pieces to tighten mine up, with no luck. With my wire welder I added a little extra to the head of the rivet so it would stop at the notch sooner. The disc goes on tight enough that there is no action...- windrow12
- Post #1
- Forum: John Deere
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy