Recent content by WindyFarm

  1. W

    Rust on loader cylinder piston

    Thanks for all the good tips guys. I'll do the grease and keep an eye on the pits. If they get any worse I might give the JB Weld idea a try. The only way I can fully retract the cylinders is to lift the front of the tractor off the ground or disconnect the loader so I'll do the grease routine...
  2. W

    Fuel gauges for 4300 and 5210

    Thanks Jim. I had searched that site before but went back in anyway and found out I didn't dig deep enough last time. Was able to find replacement part numbers for both tractors, pretty pricey. Found a cheaper one on ebay for the 4300 but not for the 5210.
  3. W

    Rust on loader cylinder piston

    Hi all, Just took my JD5210 out of winter storage and noticed one of the loader lift cylinders has some rust spots on the piston in the chromed area that retracts into the cylinder. Worried that these may harm the seal and cause it to start leaking. I cleaned them as best I could with some fine...
  4. W

    Fuel gauges for 4300 and 5210

    Hi all, I have 2 tractors, a 4300 and a 5210, with broken fuel gauges and I can't find part numbers for either one. I searched the forums here but couldn't find anything. Is there some alternative source for gauges that will work for these machines? Thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top