(800) 853-2651
SHOP NOW

Recent content by wkellen

Yesterday's Tractor Forums
  1. W

    1963 1010 RUS hydraulics

    Great info! Thank you so much. It gave me the GPM rating of the power steering part of the hydraulic pump (if equipped, mine isnt). Nowhere did it give info on GPM flow of the hydraulic pump only. I did find more useful info in the manual. My PTO shaft just quit and it shows all the parts...
  2. W

    1963 1010 RUS hydraulics

    The lift arm and hydraulic pump system is the one I am talking about. I want the pump specs though.
  3. W

    1963 1010 RUS hydraulics

    Supposed to be GPM.
  4. W

    1963 1010 RUS hydraulics

    I have looked through 2 different spec sites on this tractor and can't find what hydraulic pump is on it or what the GMP rating is on it. I would think it is low since the fluid capacity is 4.5 quarts. Anyone know for sure? Thanks, Wayne
  5. W

    Tractor HP ratings

    I have checked it over and over. At full throttle it is 26 degrees BTDC just as the manual calls for. It does seem to jump around a lot. One time it will be dead on and the next the 26 line isnt even in the window. It doesnt sound like it has a miss or anything to make it jump around though and...
  6. W

    Tractor HP ratings

    There is a project I just found called Speeduino. It looks to be incomplete, but I havent read everything on it yet. I do plan to look into it though. If by using all of these sensors, I have to build a circuit to interface to the arduino with each one, I may have the cost of the microsquirt...
  7. W

    Tractor HP ratings

    I just read through some of your posts about the MH44 EFI. Looks like you started out about the same as I am. I wasn't going the mega/micro squirt route, but after seeing the tuner software hooked up to it while running, I am now thinking about the $300 module. I was trying to accomplish the...
  8. W

    Tractor HP ratings

    I used the fuel usage numbers from the tractor specs and calculated that it is supposed to use about .1162121 cc/revolution. From this I calculated that using 2 of the donor injectors, they will have to be open 34.86 milliseconds total per revolution. Being a 4 cylinder and using 2 injectors, I...
  9. W

    Tractor HP ratings

    Oh I had a plan. It just turned into a bad plan when I decided to adjust without killing it first.
  10. W

    Tractor HP ratings

    "double RPM, double HP"... Funny you should mention this. I have an aftermarket Tach on this tractor. It works off of the wire from the coil. I had a lot of trouble getting the RPM's up a while back. I was shooting for 2500 MAX. I could only get just under 1500. After messing with timing and...
  11. W

    Tractor HP ratings

    I grew up on a couple of 4020 Diesel tractors. A shot of ether and they would fire right off. I miss them now. They were never under powered. We put a front end loader on one of them and used it like a dozer. I would think this 1010 would be a lot more powerful and reliable if it were Diesel...
  12. W

    Tractor HP ratings

    I have a John Deere 1010 RUS. I see the specs online with horsepower ratings at the 3pt hitch, drawbar, and PTO. It shows 30 hp. I know this old tractor doesn't give me this and I wouldn't expect to see it. However after some tuning, it has come to life. Especially when I got the RPM's up to...
  13. W

    8N steering problems

    I hope it doesn't need a whole new box. The tractor probably isnt worth the price of the box.
  14. W

    8N steering problems

    So it looks like Part Number: 8N3505 will at least be what I need. I may go on and order that to have on hand for when I tear into it. Thanks for the help! Wayne
  15. W

    8N steering problems

    The Ford 8N just stopped turning left. If you turn the wheel to the right, it will move the wheels, but if you turn it left the wheel spins very free. It spins up out of the steering shaft probably an inch or 2 and then locks up. After some reading on here, I am thinking one of the 2 thrust...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top