(800) 853-2651
SHOP NOW

Recent content by wremele

Yesterday's Tractor Forums
  1. W

    Update 3. Chevy C60 brake problems

    After having blocked off the MC 1st, then the booster, results were instant hard pedal from both units. Hooked up the total system and power bled from the MC, twice. 1st stroke of the pedal has the pedal going nearly to the floor regardless if the engine is running or not. Bled the system 3...
  2. W

    Update to the Chevy C60 brake problems.

    The system is not loosing any fluid as pedal is pumped.
  3. W

    Update to the Chevy C60 brake problems.

    Had pedal pumped to max pressure. Cover of MC off. Had pedal released. Fairly large fountain returned. Engine has been off for 80% of these testing periods.,
  4. W

    Update to the Chevy C60 brake problems.

    [/img:d6fc7eed8d]
  5. W

    Update to the Chevy C60 brake problems.

    After going thru all of the great advice from the replies to my original post I accomplished the following....All shoes were adjusted to lock the wheel and backed off slightly. Made a pressure bleeder and adapter for the MC. Bled all 5 points with a good stream from all of them. Never saw any...
  6. W

    1965 Chevy C60 brake problem

    Drums have been chkd for being round. Brake shoes are in very good shape with a lot of lining left.
  7. W

    1965 Chevy C60 brake problem

    I did not bench bleed the MC. Relied on bleeding after mounting on the firewall.
  8. W

    1965 Chevy C60 brake problem

    Clutch is manual. I do need to find a new boot?cover for the clutch arm where it passes thru the bell housing.
  9. W

    1965 Chevy C60 brake problem

    No doubt. I'm too old for that kind of excitement!
  10. W

    1965 Chevy C60 brake problem

    I did adjust all of the wheels to where the shoes are dragging a bit. From your description I think I will go back and adjust til the wheel won't turn and back off a bit as you say. I did have the brakes down to the backing plate and lubed the adjusters front and rear.
  11. W

    1965 Chevy C60 brake problem

    Installed new master cylinder, new Hydro-vac booster. 6 new wheel cylinders, replaced various brake lines as needed. All bleed points bled as peer normal starting with farthest from the master cylinder 1st. After 6 applications of the brake pedal the pedal becomes very hard an holds pressure...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top