Recent content by ycanby

  1. Y

    H missing badly

    You do the same, Thanks!
  2. Y

    H missing badly

    Thanks,Is that the gap for the H4 magneto?
  3. Y

    H missing badly

    I just put in Autolite 3116 plugs yesterday and did away with the D15y champions. Two of the champions had raw gas on them, figured they were the ones missing, the other two were a bit sooty, but not bad for being in 17 years. The tractor ran better for a little while, though still started hard...
  4. Y

    H missing badly

    Hello, I have a '41 H with an H4 magneto. Low hours on engine and Mag rebuild. It started missing badly all at once, perhaps down to two cylinders. The mag checks out good. Adjusting the timing on the mag does no good. Was wondering if the mag drive gear could have sheared a key and slipped on...
  5. Y

    C-263 carburator

    Hello, I have a 656 and a 706, both equipped with the C-263 gas. They appear to have the same carbs on them. I need to rebuild the one on the 706. I was wondering what brand they came with, as I need to know for ordering a kit. Thanks, YVC
  6. Y

    Case IH 3394

    Thank you all for all the help. Probably stay away from the 3394.
  7. Y

    Case IH 3394

    I was wondering if anyone was familiar with the Case IH 3394. I think it may have been made by Case before they merged with IH. Will an IH 2350 loader fit on this tractor? Also wondering how the transmissions were in these. It has a power shift. It is up for auction in our area and I thought it...
  8. Y

    1066 external voltage regulator location

    Thanks for the location. This one is definitely externally regulated as the alternator had the two wire blades side beside on the back instead of the two blades next to each other on the curved part of the alternator. I had the back of the alternator changed and the internal regulator put in it...
  9. Y

    1066 external voltage regulator location

    Hello, I am in the process of upgrading the original wiring on my 1971 F1066. Putting a self-exciting one wire alternator on it. I wanted to find and remove the old external regulator but can't find it. I was wondering where it might be. Didn't want to have to remove anymore sheet metal than...
  10. Y

    Radiator for a 1066

    Hello, I was wondering what my best course of action is in fixing a leaking and probably deteriorated radiator on a 1976 F1066. The shop says it is rotten and needs a new core. I want to put one back in that will last somewhat long as the original. Is that possible? Thanks!
  11. Y

    Farmall H running rich

    Hello, I have a 1949 H that is running rich and gas fouling the plugs, particularly #1 and 2. We recently put a new after market manifold on it. Also it has had new plugs, points, and condenser. Also a new carburetor fuel screen put on it. Any thoughts as to why it would be gas fouling the plugs...
  12. Y

    Farmall H 12 volt coil

    Hello, my son has a 1949 H that has been converted to 12 volt. It appears to use a 12 volt Ford car coil. It still uses a resistor block ahead of the coil. Is this necessary when the coil is already 12 volt?. Thanks, YVC
  13. Y

    Farmall H missing

    Hello, I have a Farmall H batt, distributor ignition type that has taken to missing badly. I cleaned and gapped the points (.020) and the plugs (.023).It has new wires with stainless conductors and new plugs. Is there anything else in the ignition or could it be carburation or valve trouble...
  14. Y

    Case IH website

    Thanks, I was starting to think it was my computer and the pitiful internet here. Will give Messicks a try.
  15. Y

    Case IH website

    Hello, Any one know why the Case Ih parts web site doesn't seem to work. Thanks, YC
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top