(800) 853-2651
SHOP NOW

Recent content by Yohon45

Yesterday's Tractor Forums
  1. Y

    Farmall 350

    Only asking because I found an H wide front for dirt cheap. Wondering if I can make it work
  2. Y

    Farmall 350

    I have a narrow front on my 350 right now but looking to add a loader to it and a wide front. Problem is finding one... Will an "H" wide front fit on the 350? I have been told the M wide front will not work.
  3. Y

    ALLIS B

    We timed the Mag using the impulse coupling method, good spark and gas flow, good compression. Checked the inspection hole and have it centered.
  4. Y

    ALLIS B

    OK, got her all put back together and painted, however now it seems to be an ignition issue. We have spark and have set the timing. It burns the gas coming in when we pull it around but it doesn't seem to want to fire on its own and stay running. Thoughts?
  5. Y

    ALLIS B

    Ok finally back it tonight. Plus are out and motor turns easier with no compression. We have the shifting forks out and can easily crank the motor but when I engage the pto I get about 1 full crank with the hand crank and it locks up.
  6. Y

    Case 600

    Yea I asked him to do that-doesn't seem like the most tech savvy guy. I assume he got that serial # off the engine, not the plate.
  7. Y

    Case 600

    Been talking with a guy on CL about a "Case 600B" which he swears up and down is the model #. I told him its likely a 610B or 611B, both of which I would be interested in. However he sent me the serial # and told me he got it off the stamped plate on the dash. He says it's 57R07203, for the life...
  8. Y

    ALLIS B

    Yes when it is in neutral and 1 wheel off the ground the wheel spins freely, same when we tried the other side. We tried all forward gears and each time it fails to turn the motor over. We are you g to try the ATF and pull g it around with out the plugs in. Hopefully that does the trick....just...
  9. Y

    ALLIS B

    That's where we are stumped because we can hand crank the engine fairly easily from the front but as soon as you try to spin the tires from the rear it's like nothing wants to move we tried all three forward gears and it still didn't move the engine we will pull the plugs and put ATF on it and...
  10. Y

    ALLIS B

    Ok tried that, still nothing all it wants to do it turn the other tire, nothing moving in the front end
  11. Y

    ALLIS B

    So I got the rear lifted up, in gear, tires spin fly wheel and motor dont move. Feels like it's in neutral....any thoughts?
  12. Y

    ALLIS B

    Ok, will try and mess with the gears tonight and see how it goes. That would explain why it wouldn't turn the motor over.
  13. Y

    ALLIS B

    Yes it does roll freely when in neutral but when it is in gear, even when we have it lifted up the wheels go opposite direction
  14. Y

    ALLIS B

    That was one of the first things we did. Everything shifted fine-fluid was milky so we will replace that- but as far as we could see the forks were in the right spot and everything seemed normal....will double check it tonight
  15. Y

    ALLIS B

    Yes, and once it was all buttoned up we filled it up with synthetic oil and have been cranking it over everyday to make sure it stayed lose.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top