(800) 853-2651
SHOP NOW

Recent content by YooperFarmall

Yesterday's Tractor Forums
  1. Y

    Saginaw for SMTA

    Saginaw photo using two original horseshoe draw-bars
  2. Y

    4 Star manifold head shield

    We recently painted our 4 Star. I've seen a lot of 4 Star hoods burnt out right next to the exhaust manifold. Is anyone protecting the hood with a head shield? If so, what are you using?
  3. Y

    JD 1010 power steering issue

    Im wondering if a loose worm gear would result in the same steering performance. The worm gear appears to be in good shape, Im wondering about any possible adjustments
  4. Y

    JD 1010 power steering issue

    Jim.ME, thank you for your response. Yes, the donor tractor was also a 1010, it was a non-running tractor so the power steering was not tested. He did rebuild the components before reinstalling them. He does not have the SM2033 service manual but on your suggestion, he is now ordering one.
  5. Y

    JD 1010 power steering issue

    I have a friend with a JD 1010 that is having power steering issues. When he is going down the road there seems to be power steering lag. He says he has to turn the wheel slightly in one direction and then quickly correct back to center. He said if he turns the wheel slightly on one...
  6. Y

    USS Hornet

    Its been almost 77 years and I think its still running!
  7. Y

    Looking for 4 Star parts

    Hoping someone can offer some suggestions where I might find the following parts for my '59 4 Star. 3pt chain limiter brackets 30A1230 & 30A1231 two of each Swinging draw-bar roller assembly 10A 9016 & 10A3820 3pt adjustment leavers 10A10954 & 10A955 Top link clip 10A14603 Thank you!
  8. Y

    Identify this JD H attachment

    A friend of mine says this part pictured came with his John Deere H. He has since painted and re-sold the H. What is this part for?
  9. Y

    Farmall H throttle control swivel linkage

    Thanks Jim. I should have mentioned I didn't take a picture of my actual linkage, I found this picture online as an example, mine isn't in this good of shape.
  10. Y

    Farmall H throttle control swivel linkage

    The throttle control swivel linkage pictured here connects to the head-mounted bracket with a cotter pin through the hole near the bottom of the picture. Either the bracket or the connecting linkage must have a fair amount of wear because it seems a little sloppy. I can get new springs from...
  11. Y

    Clutch and seals project

    Hello dgoodman2, sorry for the delayed response. It is a buddy's shop, I was hoping to get back the following weekend and take some pictures for you but got busy. It is an electric lift, it is rated at 1,000lbs. The lift runs on a track north and south, and the two end connecting points are...
  12. Y

    Drain off frozen water from a 504 hydraulics

    A friend of mine is working on a 504. He went outside today in 25 degree weather and he said the hydraulics are frozen, the steering won't work and the bucket won't go up. He is dragging it inside a heated shop. Once the tractor is heated overnight, where would he drain off the excess water...
  13. Y

    Wheel weights for a JD 1010

    Interested, sent you an email Thanks
  14. Y

    Mackinaw bridge run.

    .
  15. Y

    Wheel weights for a JD 1010

    Looking for a set of rear wheel weights for a 1010, wondering if anyone has suggestions where I might find a set or part numbers etc. Thank you in advance
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top