Allis 1938 B hole

[yorke]

I found a hole between tran. Drain & clutch inspection plate I got some crud out of it maybe 1/4" can get scredriver up to top. That not clutch inspections hole. Not sure what it is
Thanks for your time & knowledge

 

[rustred]

Tractors usually have a hole there in the bottom so the oil can run out. If the front trans input shaft seal leaks , or the rear main seal leaks. You don’t want oil on the clutch.

 

[yorke]

Thanks for your knowledge & time

 

[Jim.ME]

The link below should take you to the Allis Chalmers manual that covers the G, B & C and the CA models. It is broken up in sections for those models.

AC manual for G, B & C, CA

 

[yorke]

The link below should take you to the Allis Chalmers manual that covers the G, B & C and the CA models. It is broken up in sections for those models.

AC manual for G, B & C, CA

Thank U for your time

 

[Watthour]

The "B" I had included an inspection hole on one side for ignition timing marks. Is that what you are seeing?

 

[yorke]

The "B" I had included an inspection hole on one side for ignition timing marks. Is that what you are seeing?

My 1938 B i think was hand crank B11284 then converted to battery.
I will look next trip for the inspection plate hole U speak of. That welded piece was were genatator was mounted???
Thanks for your time