Is this TO-30? I trying to find parts thanks in advance

[buzzytll]

 

[used red MN]

Hello buzz.., welcome to YT! If that is the original engine the Z129 came in the TO30. Looks like a ‘53 model by the serial number.

 

[pomester]

serial number says 1949 TO-30

ebay is your friend - TO-20 should be the same. check with this fellow -

Edit: Looks like I was looking at the English serial numbers. Agree with used red, TO-30 numbers say 1953

 

[buzzytll]

Hello buzz.., welcome to YT! If that is the original engine the Z129 came in the TO30. Looks like a ‘53 model by the serial number.

Thank you ..iam just having trouble finding that 3 point for some reason. So I wanted to confirm it is a 30 thank you

 

[pomester]

Thank you ..iam just having trouble finding that 3 point for some reason. So I wanted to confirm it is a 30 thank you

One thing you could consider is installing a Ford 8N top cover and pump. This would give you position control on the 3 point arms. The pump bolts right up, the top cover requires some modification to the housing area of the tractor. It might actually be easier to find 8N parts vs Ferguson.

I did this modification on a TO-30 a couple years ago and while I found it not as straightforward as my research indicated, it's been working well and I am happy I did it. Being able to hold the 3 point arms at different heights is very handy.

Here's a thread I did about it. https://forums.yesterdaystractors.com/threads/to30-position-control.1648719/

 

[Dieseltech]

Where is the oil filter? If it's INSIDE the oil pan it's a 20. The TO 30 has the oil filter outside under the carb.

 

[buzzytll]

ThaOne thing you could consider is installing a Ford 8N top cover and pump. This would give you position control on the 3 point arms. The pump bolts right up, the top cover requires some modification to the housing area of the tractor. It might actually be easier to find 8N parts vs Ferguson.I did this modification on a TO-30 a couple years ago and while I found it not as straightforward as my research indicated, it's been working well and I am happy I did it. Being able to hold the 3 point arms at different heights is very handy. Here's a thread I did about it. https://forums.yesterdaystractors.com/threads/to30-position-control.1648719/

Thank you