White 6145 transmission no gears eather direction

KidHibbitts

New User
I have a 6145 white and it will not move in any gear, or any direction. Fluid level is good,transmission filter has been changed. All the solenoid ohm out according to specs. Wiring harness checks out as well. Recently replaced the TCU with reman. Pilot/ lube pressure is about 250 psi. PTO shaft will engage. Three point lift works fine.

Does anyone have any suggestions??
 
I have a 6145 white and it will not move in any gear, or any direction. Fluid level is good,transmission filter has been changed. All the solenoid ohm out according to specs. Wiring harness checks out as well. Recently replaced the TCU with reman. Pilot/ lube pressure is about 250 psi. PTO shaft will engage. Three point lift works fine.

Does anyone have any suggestions??
Is it throwing any codes in the dash? It’s not a “common” issue with those tractors but it has been known to happen. However normally cycling the key a few times or at most disconnecting the battery for a few minutes has got them moving again. Maibach tractor has some mechanics that are pretty well versed in 6000 series so if neither one of those things solve your problem I’d give them a call.
 
I had a 1996 Ford with that same transmission, that did the same thing. It was because the seal for one of the clutch packs was badly worn so that it couldn't build adequate pressure. When one is bad the others are close behind. Your owner's manual should give you the procedure for doing a transmission self test. It will give you refill values for each clutch pack. How many hours? You are most likely looking at a complete transmission rebuild.
 
Is it throwing any codes in the dash? It’s not a “common” issue with those tractors but it has been known to happen. However normally cycling the key a few times or at most disconnecting the battery for a few minutes has got them moving again. Maibach tractor has some mechanics that are pretty well versed in 6000 series so if neither one of those things solve your problem I’d give them a call.
Done all that even put in new batteries because they were low on CCAs. Do you have a number for Maibach? I've never heard of them.

Thank you
 
Is it throwing any codes in the dash? It’s not a “common” issue with those tractors but it has been known to happen. However normally cycling the key a few times or at most disconnecting the battery for a few minutes has got them moving again. Maibach tractor has some mechanics that are pretty well versed in 6000 series so if neither one of those things solve your problem I’d give them a call.
No sir. Not throwing any codes. Sometimes it might flash 45 briefly one time but not consistent.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top