International 584 wheel hub sleeve…

[Massey_165]

Replacing the wheel bearings on my international 584, I know the back of the hub has a sleeve, I got one out but it looks like there might be another piece in it, should that lip be there or should I try to get it out? You can zoom in on the picture and see a ring around the edge.

 

[Centerplate]

Before you try to dig it out, compare it to the replacement seal.

 

[urbancase]

I have a 584 but never had to deal with that. I have a IH R&R book if you need info let me know and look that up and send to you.

 

[Massey_165]

Before you try to dig it out, compare it to the replacement seal.

This is the new vs the one I pulled out, it seems thinner, but maybe it wore that much. The lip on the hub is what’s making me wonder…

 

[RedMVa]

If you got the wear ring out , that’s all there is to it. Put new race in and install wear ring, the lip sets against back of hub, pretty straight forward

 

[joeysmith]

Almost looks like someone machined an oversized sleeve to fit from a past time it had been wallerd out

 

[JimB2]

We did a CIH 495 not bar axle, outer axle bearing a few years ago.
We found one of third party repair manuals had the diagram wrong for the placement of the wear sleeve, see correct placement in photo below.
Your 584 has the bar axle so the placement is the same, you just don't have to take the complete axle trumpet off to repair.

 

[RedMVa]

We did a CIH 495 not bar axle, outer axle bearing a few years ago.
We found one of third party repair manuals had the diagram wrong for the placement of the wear sleeve, see correct placement in photo below.
Your 584 has the bar axle so the placement is the same, you just don't have to take the complete axle trumpet off to repair.




View attachment 155536

Uh Jim pretty sure he’s doing a front hub

 

[JimB2]

Uh Jim pretty sure he’s doing a front hub

After close examination I think you are correct, I had notice the two slots like bar rear axle key slots and assumed it was rear axle hub looks too small.

 

[Massey_165]

If you got the wear ring out , that’s all there is to it. Put new race in and install wear ring, the lip sets against back of hub, pretty straight forward

Ok, I’ll clean it up and try to press the new one in.

 

[Massey_165]

Almost looks like someone machined an oversized sleeve to fit from a past time it had been wallerd out

Yeah it does kind of look like that don’t it, hmm.

 

[Massey_165]

I have a 584 but never had to deal with that. I have a IH R&R book if you need info let me know and look that up and send to you.

Yeah that would probably be helpful.

 

[Massey_165]

Got it in.