KChallener
New User
I am restoring a 1972 JD 110 square fender with a 10 HP Kohler. The tractor was disassemble when I got it. I have an adjustable seat (4 shoulder bolts, two L shaped brackets and a rod with spring). I need help with the bracket and rod location, seems to want to rub on the deck any way I set them up. JD manual is no help. A picture would save the day. Also, I need help with routing on the choke and throttle cables around the block. I have a clamp on the cover for the fuel pump (not used on this motor) which appears to go to the throttle cable. No clamp for the choke, so I need to know where that attaches. Seems that the cable are too short to run in the obvious places, and cannot go under the motor frame as far as I can tell. A picture where the go past the block would ge great (along the steering column, under the battery tray and then...). Same question of the wiring harness. Harness from HAPCO does not reach the neutral safety??? Thanks in advance.
