JD 2020 load shaft seal/retainer /shaft kit

[mite-help]

HELLO ALL . I am looking for the loadshaft seal kit for this JD 2020 . i can find kits on line [including this store] but they all jump over 2020, with some pictures looking like what i need. any interchange with other models ? thanks

 

[Jim.ME]

HELLO ALL . I am looking for the loadshaft seal kit for this JD 2020 . i can find kits on line [including this store] but they all jump over 2020, with some pictures looking like what i need. any interchange with other models ? thanks

I expect at least some of the parts are used on other models but not all may match what you need. Do you have a parts catalog or use the one online? It appears the 2020 used a couple different load shafts based on serial number. Do you know which one you need?

If you don't have a parts catalog, I have attached a link to the online one for the North American 2020 (assuming that is the one you have). Look in the hydraulics section to find the load shaft to find the part numbers you need, and you can use them in your search.

PC971 for JD 2020

 

[mite-help]

thank you sir. vin tag is bent over will try to make it out today

 

[mite-help]

Is there any other place to find vin # other than tag on frame rail?

 

[Jim.ME]

The serial (VIN) number is only on the tag as far as I know. Can you smooth the tag up as best you can and post a picture of it. Or post everything you can read from it in the order you see it?

Tx Jim will correct me but if the serial number tag is on the right frame rail, over the front axle, it sounds like you have the European version 2020. If that is the case, you likely need the parts catalog in the link below. The parts catalog I previously gave you is for the North American 2020 with the serial number tag on the right side of the transmission, above the foot board.

PC4164 parts catalog for European built JD 2020

 

[mite-help]

thank you!! will go to where the tractor is today & see what i can make out

 

[MSD]

I have had pretty good luck sealing them up by putting an o-ring in. Take the seal to a good hydraulic shop and find a maching o-ring. Cheap and easy way to stop it from leaking for how long I don't know but so far so good.

 

[mite-help]

ok. we don't have the retaining collar & other pieces for 1 side

 

[Tx Jim]

Is there any other place to find vin # other than tag on frame rail?

2020 only had serial # tag under RH side of trans case under seat no number stamped in RH front support similar to 30 & up series JD utility tractors

 

[Jim.ME]

2020 only had serial # tag under RH side of trans case under seat no number stamped in RH front support similar to 30 & up series JD utility tractors

I have seen info that says the 2020 and 2120 built in Europe (and maybe Mexico) had the tag on the front support.

Here is a page from the Mannheim built 2020 Operator's Manual OML25199.

 

[Tx Jim]

Thank you for correction. I should stated 2020 built for sales in USA didn't have serial # on RH front support.