Looking for a track roller, 1957 Case 800 Terratrac dozer

[mr_roboto]

Need a track roller, with or without the shaft is fine. I need the end nut. Bearings do not have to be good, I can rebuild. I can provide a shipping label.

Or something that will fit. (OR if anyone knows something close). 5" OD where the chain rides, 3" outside between the flanges, 1-3/4" shaft where it goes through the mount. Shaft is about 9" long. I'm going through listings but of course few list dimensions.

(I've followed the chain of superceding part numbers to a currently available part number, CNH 122501A1. Once I get the part in, I will post what the differences are. It is a more robust part).

 

[SkipperII]

If you have a good one, for a sample, a machinist could turn one out in very short order.

 

[Case Nutty 1660]

Need a track roller, with or without the shaft is fine. I need the end nut. Bearings do not have to be good, I can rebuild. I can provide a shipping label.

Or something that will fit. (OR if anyone knows something close). 5" OD where the chain rides, 3" outside between the flanges, 1-3/4" shaft where it goes through the mount. Shaft is about 9" long. I'm going through listings but of course few list dimensions.

(I've followed the chain of superceding part numbers to a currently available part number, CNH 122501A1. Once I get the part in, I will post what the differences are. It is a more robust part).

lots of aftermarket parts suppliers for under carriage parts