6610 oil leak from clutch rod hole

[bluetractor14]

6610 II has begun leaking oil (a lot) from the clutch rod hole. Everything is working, but lost several gallons of UTF fluid in a small stream just pouring out, Rear axle dipstick showed barely in "Add" range so filled up to "Safe", disconnected mower and it all ran back out. Anybody got perspective on this? Thanks.

 

[matthies]

6610 II has begun leaking oil (a lot) from the clutch rod hole. Everything is working, but lost several gallons of UTF fluid in a small stream just pouring out, Rear axle dipstick showed barely in "Add" range so filled up to "Safe", disconnected mower and it all ran back out. Anybody got perspective on this? Thanks.

If it doesn't have a cab, you can take off the 4X5 rubber plug on the right side and take a look in the clutch housing. I just had one split for a small leak in the same area, was an oring on the line that the prementioned rubber plug goes over and into the front of the transmission. The oring could be fixed through that 4X5 hole if no cab. There is a 3/16 hole in the bottom of the clutch housing that must be plugged, oil should be leaking there also. If it has a cab time to split.

 

[bluetractor14]

Thanks, really appreciate that