Super C with a Woods L306 Mower PTO Pulley Diameter

[Papa Paul]

I have a Super C with a Woods L306 Mower and would like to learn what the correct PTO Pulley Diameter is. Thank you.

 

[RedRamGT]

The manual shows it as Woods part 10720, an 18.4" pulley.

 

[Papa Paul]

Thank you. That is what I have. I am now looking for the missing shield.

 

[DaveBN]

In my experience those are always missing, yikes! One could be made fairly easily by a welding shop. It's just a sheet metal cover that wraps around two, I think, pulleys.
Dave

 

[DaveBN]

Maybe three pulleys.

 

[kshansen]

Maybe three pulleys.

My God, that is a wide tractor! There are many places I mow with my BN that it would never get through!

Thank you. That is what I have. I am now looking for the missing shield.

If you need more pictures or measurements mine is not right now on my BN, let me know. I don't know why I have it off, probably not a good idea. Then again even if it was on with the BN seat being off to the right it would not really make it that hard to get hands where they could get hurt.

 

[Papa Paul]

Thank you. I would appreciate more pictures and some measurements. I am curious as to how it is mounted. Thank you.

 

[504]

I nave had two supers with a Woods mower. Bothe had one wheel wide and the other set narrow

 

[kshansen]

Thank you. I would appreciate more pictures and some measurements. I am curious as to how it is mounted. Thank you.

Not sure if I should send a bunch of pictures to the forum or direct to your email account. Hope some one can let me know!

I'll try attaching one for now:

 

[RedRamGT]

The Woods part number for the belt shield is 25560, Burch Store Tractors has a used shield and also a new old stock shield. They might also have the brackets, too...

 

[Papa Paul]

I appreciate the help that several of you have offered. I will contact Burch Store Tractors tomorrow and inquire about the brackets as well

 

[kshansen]

I appreciate the help that several of you have offered. I will contact Burch Store Tractors tomorrow and inquire about the brackets as well

The brackets are just some say 1/8 inch flat stock maybe 1 1/4 wide. on mine the right bracket bolts to a stud on the inside of the frame and one on the left the stud is on the outside of the frame.

The pictures below show the two studs and the bottom center bracket,

 

[Papa Paul]

Thank you for the pictures. I am waiting to hear about the cover.

 

[Papa Paul]

Thanks for the help. I have the cover on the way and, based on the pictures, the brackets don’t look to be very complicated.

 

[kshansen]

Thanks for the help. I have the cover on the way and, based on the pictures, the brackets don’t look to be very complicated.

Would not take much to fab them up out of some flat stock with a little help from a hammer!