Bosch VA CR injector pump throttle pin size

[Hattrick]

Got my 574 running butbit idles around 1200 RPMs. The throttle rod moves on the pump but there is no throttle response. From what I have read this is likely a broken pin on the throttle mechanism in the injector pump and can be repaired without removing the pump. I have read that the dowel pin that is needed is 2mm x 12mm stainless dowel pin. Can anyone that has done this confirm that this is the correct dowel pin size?

Thank You

 

[JimB2]

Look at this old youtube video:

 

[Hattrick]

Thanks. This is a more specific video on how the repair the broken pin. I was just looking to confirm the replacement pin size.

 

[JimB2]

Thank you for link to the video link.
Was it @HydroTeh from Redpower that gave you the pin size?
I believe he did post the pin size at one time.

 

[Hattrick]

 

[Hattrick]

Thank you for link to the video link.
Was it @HydroTeh from Redpower that gave you the pin size?
I believe he did post the pin size at one time.

I went over and looked but could not find the post or reply. I have some 2mm x12mm pins coning today so i will find out.