redoakroach
Member
- Location
- Red Oak, Michigan
I need to adjust the clearance at the turnbuckle and can't find my gauge. I asked the internet and got .396 for draft and .449 for control. Is this correct?
Thanks
Larry
Thanks
Larry
Andy Wickiser
Member
According to I&T FO-20 Shop Manual those numbers are correct.
OP
OP
redoakroach
Member
- Location
- Red Oak, Michigan
thank you Andy
OP
OP
redoakroach
Member
- Location
- Red Oak, Michigan
So did I. But it seems to have disappeared some time in the last 30 years. LOL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy