Struggling to seal 3000 injection pump

Mudrig150

Member
I'm struggling to seal the injection pump on my 3000. It's now on gasket number 4 and still leaking. The first gasket blew out from excess pressure under the top cover of the injection pump, and each subsequent gasket has seemingly failed from being sliced in half by the top cover. I installed a new gasket today, but took extra precautions, including filing the sharp edges off the top cover, flattening it with glass and 1000 grit sandpaper, and checking the top cover for flatness. After doing all this, I put the top cover back on with sealant to help the gasket as much as possible, and it didn't even hold against fuel pressure before leaking this time. I'm genuinely at a loss as to what to do short of pulling the pump and having them machine the gasket surface to attempt to flatten it back out.
 
I don't have much injection pump experience, but it doesn't sound like the gasket or sealing surface is the issue. With how much you've prepped the mating surfaces and with how many gaskets you've gone through, I think it's too much pressure. Is there a pressure relief/regulator? Is the return circuit clear and flowing well?
 
I don't have much injection pump experience, but it doesn't sound like the gasket or sealing surface is the issue. With how much you've prepped the mating surfaces and with how many gaskets you've gone through, I think it's too much pressure. Is there a pressure relief/regulator? Is the return circuit clear and flowing well?
There's a pressure relief for the rotor side of the pump but there shouldn't be any pressure on the top side, it's like there's something under the top cover keeping it from fully seating but I'm not sure what it could be.
 
I'm struggling to seal the injection pump on my 3000. It's now on gasket number 4 and still leaking. The first gasket blew out from excess pressure under the top cover of the injection pump, and each subsequent gasket has seemingly failed from being sliced in half by the top cover. I installed a new gasket today, but took extra precautions, including filing the sharp edges off the top cover, flattening it with glass and 1000 grit sandpaper, and checking the top cover for flatness. After doing all this, I put the top cover back on with sealant to help the gasket as much as possible, and it didn't even hold against fuel pressure before leaking this time. I'm genuinely at a loss as to what to do short of pulling the pump and having them machine the gasket surface to attempt to flatten it back out.
Had same problem and found on the 3rd attempt, the return line was plugged at the pump cover fitting... Blew/remove out the debris and then gasket worked perfectly. Couple weeks later, I starting thinking that the pump on my '86 power stroke doing similar, and that this pump may be in the final stages of the governor disk disintegrating??? Sold tractor before I could find out. Hope I did not pass on problems.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top