ford 420 3 cyl. deisel won't start

davidpick

IH David
Hi you all, I bought a Ford 420 not running on a trailer. I was told it ran to get on trailer. Sat on trailer for long time, wouldn't start. I replaced fuel system, drained tank, new lines, filter. A new hipresser fuel pump was installed, new injecters. Can get white exhaut smoke, sometimes a little brown. Come back a weak later have to prime again. Nothing looks lose, can not figure where air can be getting in. I thing pump issue, alot of money to replace. Any help would be nice.
Thank you
 
Forgive me for asking the obvious, but were all the injector lines properly bled, at the injector, after the fuel system work? Did you have good fuel pressure at those connections while bleeding?
 
Are you posting that you replaced the injection pump and you think that you need to replace it again???
 
If I read your problem correctly you have air in your system. If you have a CAV pump, there is a small screw on the side of the pump.....takes an 8mm wrench to remove it. With the screw out crank the tractor and you should have fuel squirting out. If not, your pump isn't getting fuel.

If you are ok there, then replace the screw and go to the injectors. Crack the fuel lines to the injectors....half a turn or so open.....crank the engine again and expect to see fuel squirting out each cracked line on every injector, every time that injector is selected to get fuel. Once you have that....when you have that, while still rolling the starter lock down each injector fuel line nut....by the time you get to the 3rd or 4th injector it should have been running (rough) on its own.

If you fail both of those tests then you could expect a pump problem....do you know if you got it reinstalled correctly so that the timing of the pump corresponds to the crankshaft coming up on the compression stroke for the correct cylinder getting a squirt of fuel?
 
I have bled all the lines at the injecters and the 8mm bolt on the side of the pump. Somewhere air is getting back in the system???
THANK YOU
 
Let’s try again, you installed the new injection pump or it came on the tractor? Trying to find out how long it has sat unused with this pump on it? This new blend of diesel can cause problems with sticking parts in the pump in under 6 months.
I am trying to figure this all out too.
 
You said you bought it. Did you ever hear it run? Do you know any history on it? Was it torn down at one point and ever started since? Throw us a bone so we're not throwing every single possibility on Earth at it?

My brother bought a diesel crawler one time that had been through three owners and nobody could get it to run. I tore it down and all of the rings were stuck. It didn't have enough compression to start.
 
no never heard it run. Said it ran to get on trailer. It has something to do w/ lucas/cav pump. I was told it was new, but the top cover had a home made gasket ? It came with another new pump w/ cracked inlet port. Looked like it had been dropped, cacked alum. fitting. I switched it out w/ one on tractor. I don't know for sure about little parts and springs, a few different models. Either way it shouldn't leak air. I seem to lose the prime over time, everything seems tight.
Thank you
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top