Ford 3000 spark plug wire placement.............

Have you tried putting your finger over #1 spark plug hole and feeling for compression? It's not that hard. Once you feel compression keep turning crank(slowly) with your tie wrap in hole until it stops at TDC this is when rotor should be pointing at #1 plug wire on cap and flywheel mark should be darn close to 0 deg.
 
That makes sense if one crank shaft revolution = half a rotor revolution.

By the way I would recommend a you tube video titled "Ford 4000 tractor ignition system service & repair".

Best Ford tractor video I have seen even if your tractor isn't a 4000.
 
Have you tried putting your finger over #1 spark plug hole and feeling for compression? It's not that hard. Once you feel compression keep turning crank(slowly) with your tie wrap in hole until it stops at TDC this is when rotor should be pointing at #1 plug wire on cap and flywheel mark should be darn close to 0 deg.
I need both arms and hands turn pull down on the fan belt to get a clockwise turn.

Yes, plugs were loosened but still a hard pull.

I had a zip tie in #1 cylinder to monitor piston action.

And have a thick pair of gloves on.
 
Another thing. You should be turning the engine the same direction as it runs to keep gear slack in the right direction. That direction would be clockwise if looking at the fan when standing in front of the tractor. Counterclockwise if setting in the seat looking at the fan.
 
Old Indian trick, remove the spark plugs and your life will get easier.
Back to basics the crank turns 2x for every 1 turn of the camshaft. Back to the 4 stroke cycle thing that you have to understand to work on a gas tractor. Piston starts at the top, down stroke is intake, then it comes up next is compression stroke igniting the charge crates the next stroke which is power followed by the next upward stroke which is exhaust. Get it to keep repeating and you have a running engine.
 
The tractor is running fine now.

The only prep work on the new carb was moving a gas fitting from the front of the carburator to the back and putting some locktite on the course threads of the two studs and getting two new fine thread nuts and lock washers.

I fit the carburator last night before dark and tightened it and the hoses this morning.

The only adjustment I had to make was turning the throttle body rod connector out a few turns.

I removed the Partsquest coil I bought a few months ago because the rubber boot kept slipping off because the coil was to wide at the top (look at photo), I ain't making this up!

I put my jumper cables on the tractor battery from my dodge journey with it running for about ten minutes, turned it over a few times then waited for the glass bowl to fill up with gas.

Tried again and it ran perfect, so good in fact I never messed with turning the timing at all just tightend the bolt down.

The choke cable, I zip tied in place until I have time to remove the old one but fit pefectly in the clamp the carburator had for it.
 

Attachments

  • Carburator.JPG
    Carburator.JPG
    3 MB · Views: 0
  • choke cable.JPG
    choke cable.JPG
    2.9 MB · Views: 0
  • coil.JPG
    coil.JPG
    2.9 MB · Views: 0
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top