806 hydraulic filter cover gasket....

Absent Minded Farmer

Well-known Member
Does that need to be there or can I get away with forma gasket?

It stands out in my mind that it needs to be there to shim the cover out a touch for the relief valve spring.

I really just want to booger it into place with some goo & get back to spreading. Just don't want to mess something up.

Mike
 
Also, make sure where each bolt goes through the cover it is not warped. If so file the spots down or it will suck air and loose hyd. prime. Have changed lots of the 06 series to the 66 and 86 series covers, then you don’t have to remove the bolts anymore to change the filter.
 
Also, make sure where each bolt goes through the cover it is not warped. If so file the spots down or it will suck air and loose hyd. prime. Have changed lots of the 06 series to the 66 and 86 series covers, then you don’t have to remove the bolts anymore to change the filter.
Myself i flatten the cover bolt holes with a flat face hammer then check with a straight edge . And ya don't need a four foot cheater when ya tighten the bolts up .
 
Also, make sure where each bolt goes through the cover it is not warped. If so file the spots down or it will suck air and loose hyd. prime. Have changed lots of the 06 series to the 66 and 86 series covers, then you don’t have to remove the bolts anymore to change the filter.
What would be nice is if someone would remake the the extension cover to stack two filters then ya could go with the 18 GPM pump and not starve the system.
 
What would be nice is if someone would remake the the extension cover to stack two filters then ya could go with the 18 GPM pump and not starve the system.
It would have been even nicer.... if the designers would have put the filter not next to a tire full of ****!

Is that two filter cover used on the 86 series? Wonder if I couldn't get one at a bone yard?

Mike
 
Update:

I got everything together & she's nice & dry. Tending to think that it needed that filter valve thing replaced for a while now. Not only was it crudded up pretty bad, the screen had a tear in it. Not too worried. The Hy-Tran still looks good as new, no sparkles, no flakes, no discoloration. Smells as good as it always does. The filter that got changed out was only 6 years old with about 180 - 200 hours on it. The paper was still clean with no signs of watery Hy-Tran snot on it. It took the whole 2 1/2 gallon jug to refill it back to the line. Also figured out the dipstick is easier to read at night with a flashlight. The steering, brakes, TA & 3PT all function better than before.

Thanks, all, for the help!

Mike
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top