TSX241B Rebuild Woes

Location
Pride, LA
I’ve rebuilt my TSX241B with all new jets after confirming the appropriate jet sizing and locations. Brand new throttle and choke shafts, springs, seals, power and idle adjustment needles as well.

I’ve combed every MS manual I can find, and all agree to start the idle adjustment about 1 to 1-1/4 turn out. I just can’t seem to get any actual idle adjustment out of the girl. I can dial it down to about 1/4 turn out before it starts to richen to the point of stumbling. And I can lean it out as much as I want past 1-3/4 turns out with no apparent change in how she’s running. I’ve tried using the old needle, new needle, another new needle. All with similar results.

I’m starting to think I might have some deformation in the casting that is keeping me from being able to adjust it properly. I’ve got a Chineseum replacement that the tractor actually really likes running on, but I’d like to get back to the original.

Has anyone else dealt with this issue and know of a fix for a (possibly) deformed idle passage? I’ve considered lapping as an option, but wanted to consult the sages before giving it the college try.
 
I’ve rebuilt my TSX241B with all new jets after confirming the appropriate jet sizing and locations. Brand new throttle and choke shafts, springs, seals, power and idle adjustment needles as well.

I’ve combed every MS manual I can find, and all agree to start the idle adjustment about 1 to 1-1/4 turn out. I just can’t seem to get any actual idle adjustment out of the girl. I can dial it down to about 1/4 turn out before it starts to richen to the point of stumbling. And I can lean it out as much as I want past 1-3/4 turns out with no apparent change in how she’s running. I’ve tried using the old needle, new needle, another new needle. All with similar results.

I’m starting to think I might have some deformation in the casting that is keeping me from being able to adjust it properly. I’ve got a Chineseum replacement that the tractor actually really likes running on, but I’d like to get back to the original.

Has anyone else dealt with this issue and know of a fix for a (possibly) deformed idle passage? I’ve considered lapping as an option, but wanted to consult the sages before giving it the college try.
Set the idle screw to 1.5 turn out from the bottom and leave it alone simple as that.
 
I can dial it down to about 1/4 turn out before it starts to richen to the point of stumbling. And I can lean it out as much as I want past 1-3/4 turns out with no apparent change in how she’s running.
Is there a performance issue from 400-6 or 700 rpms? You seem to be describing a normal idle circuit.
I've found 1/2 to 3/4 out to be good for Tsx 241-B( MS or clones) and tsx 33.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top