John Deere 1020 Gas engine what should the psi compression be?

Well, I don't run green tractors but I do know this: 7.25 to 1 compression runs 145 psi cranking compression and the same engine with 8.0 to 1 LPGas pistons runs 170 psi compression. These are the factory OEM specs. I disagree with 110 psi if the compression ratio is 7.5 to 1.
 
Last edited:
When cranking compression tests are performed, the throttle MUST be in the wide open position. If it is in the slow idle position, your numbers will be low.
 
No complaint. Don't forget 3-cylinder gas burner 7,5 compression
This tractor has sat in a shed for 12 years. I have soaked the cylinders with two ounces of a mixture of AT and 30 w oil for two weeks while cleaning the gas tank, fuel lines, fuel pump, (all full of rust so I assumed the cylinder walls also) etc. Now during the two weeks I've turned the engine over many times without the plugs and did the compression test and was wondering what it should be before I tried cranking the engine.
Do you think the oil has seeped past the rings by now? Or the test is not a dry test?
I am now ready to start it up.
 
No complaint. Don't forget 3-cylinder gas burner 7,5 compression
This tractor has sat in a shed for 12 years. I have soaked the cylinders with two ounces of a mixture of AT and 30 w oil for two weeks while cleaning the gas tank, fuel lines, fuel pump, (all full of rust so I assumed the cylinder walls also) etc. Now during the two weeks I've turned the engine over many times without the plugs and did the compression test and was wondering what it should be before I tried cranking the engine.
Do you think the oil has seeped past the rings by now? Or the test is not a dry test?
I am now ready to start it up.
If you had all the plugs out, as they should have been during the compression testing, and it is not blowing the ATF and oil out the plug holes when spinning over, put the plugs in and turn it over by hand. If it turns at least two full rotations without binding, try starting it. Worry about compression after you get it to run for a time.
 
Jim.ME
A couple of things concern me; it is difficult to turn it over by hand using the fan blade without the plugs installed.

buickanddeere,
The Cranking rpm is slow. That may be why the compression is 90 psi. The starter is turning it over slow. I don't know if it will turn it over fast enough with the plugs installed to crank. Haven't tried yet. Still waiting on other parts to be delivered.
I will have to probably pull it off to crank it for the first time.

BUT: To others, I would like to thank everyone who has offered help. This forum has a wealth of knowledge!
 
Something to consider when adding fluids to a combustion chamber. Two ounces isn't very much. Some pistons have a "bowl" in their tops and 2 ounces might not even be enough to fill the bowl, let alone get fluid on the cylinder walls and rings. Personally, I use diesel fuel and fill each cylinder until it runs out of the spark plug holes. Then, I know everything is soaked. After a week or a month, try to turn it over with the plugs removed. Any fluid that gets by the rings goes into the engine oil which will need to be changed anyway.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top