Roll-O-Matic gear teeth rebuild?

Okay everyone, so I am in the process of reassembling my tractor I realized that my front-end Roll-O-Matic was stopping far short of the stops and seizing, so I took it apart and realized that where two teeth meshed in the very center of the gear on both spindles had effective broke against one another, the wear on both the original gears on this spindle were relatively minor other than these two big teeth breaking, luckily I have another Roll-O-Matic on my parts JD 60 but upon inspection while none of the teeth are broken they are in fact much more worn down than I would like.

What are my options? I could go looking for another set that are better which would be expensive and hard in my corner of the country, (And wouldn't know the condition of the gears until I opened them, I could just put the worn pair in and call it a day even though I don't like it, I could look into getting the gear teeth rebuilt at a machine shop but given how hard the metal is and that it's cast steel I have little faith in how well it would hold up. Has anyone here had any experience with that?
 
Okay everyone, so I am in the process of reassembling my tractor I realized that my front-end Roll-O-Matic was stopping far short of the stops and seizing, so I took it apart and realized that where two teeth meshed in the very center of the gear on both spindles had effective broke against one another, the wear on both the original gears on this spindle were relatively minor other than these two big teeth breaking, luckily I have another Roll-O-Matic on my parts JD 60 but upon inspection while none of the teeth are broken they are in fact much more worn down than I would like.

What are my options? I could go looking for another set that are better which would be expensive and hard in my corner of the country, (And wouldn't know the condition of the gears until I opened them, I could just put the worn pair in and call it a day even though I don't like it, I could look into getting the gear teeth rebuilt at a machine shop but given how hard the metal is and that it's cast steel I have little faith in how well it would hold up. Has anyone here had any experience with that?
Or run the worn one until it's craps out then make up your mind. That's probably the route I'd Go.
 
Are the gears identical?? if so, maybe swap them right/left and left/right and the wear should be on the unused side.
The parts catalog show RH and LH pieces but there may be a way around that. A & L Parts most likely has used ones. Penn Yan, NY 315-536-0543 M - F.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top