8N Marvel-Schebler leak at the choke arm - again

CFB

Member
Today was the big day when the tractor, now all assembled after several years of restoration, would start all up. It almost did. The two area I was afraid of worked, but the ones I didn't, well, didn't work. Several years ago, I had a flood of gas on the floor. It leaked out of the choke arm entry. At that time I thought packing had deteriorated and came out thus causing the leak, but the forum said I have a problem with a needle or float or both as gas level should stop below that choke arm. So I replaced needles, flushed all jet holes and put a new float in. Same problem. Is there a way I can test the needle and float before I mount it on the tractor to see if all is working? thanks
 
Today was the big day when the tractor, now all assembled after several years of restoration, would start all up. It almost did. The two area I was afraid of worked, but the ones I didn't, well, didn't work. Several years ago, I had a flood of gas on the floor. It leaked out of the choke arm entry. At that time I thought packing had deteriorated and came out thus causing the leak, but the forum said I have a problem with a needle or float or both as gas level should stop below that choke arm. So I replaced needles, flushed all jet holes and put a new float in. Same problem. Is there a way I can test the needle and float before I mount it on the tractor to see if all is working? thanks
Is the new needle a rubber tipped one?? If it is it has to have a set put in it or it can leak so one needs to drop the needle in the seat and tap on the needle a few times to put a set in the rubber tip
 
The choke shaft is in what should be a dry air passage, there should never be liquid gas enough to get up to the choke shaft level. heavy choking can sometimes get some gas dripping out the sintered bronze in the drain hole of the air passage.

Needle not seating, bad float (or binding float), float level not set right can cause your problem.

After checking the needle, float and setting, before you put the carb halves back together, turn the top half upside down and see if you can blow in the inlet. If the needle is seating, you should not be able to blow through the inlet fitting.
 
Thank you for confirming that gas should not be coming out the choke shaft. Thanks for the tip to try before assembling.
 
Is the new needle a rubber tipped one?? If it is it has to have a set put in it or it can leak so one needs to drop the needle in the seat and tap on the needle a few times to put a set in the rubber tip
well, its been awhile, but now that you mention it, I think it is - as I remember it looked different than the one I took out. Interesting - I'll definitely tap on it. thanks
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top