(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. M

    1984 c20 backfiring

    Hi, I bougjht a 1984 c20 with 4.1 l6 engine.4 speed manual It starts easy , a little rough while warming up. When driving it backfires through the exhaust almost every time i shift, never backfires other times, new plugs, wires rotor and cap, timing set correctly, valves are all good. previous...
  2. M

    Oil Plug Screen

    Hi, I bought a 9n last Sept. Oil was real clean so I left it untill now, I used it every other day since I have had it. Runs Great. yesterday I changed oil 10/30,filter ect. when i dropped the plug there was no screen. i felt up inside and still no screen. There also appeard to be no sludge at...
  3. M

    9n hyd oil topping off

    I need to add a small amount of hyd/trans oil, what is in there now i have no idea, but it is very clear and clean, not knowing what it has, what type would be safe to add
  4. M

    9n hyd oil topping off

    I need to add a small amount of hyd/trans oil, what is in there now i have no idea, but it is very clear and clean, not knowing what it has, what type would be safe to add
  5. M

    OT hard starting log splitter

    i have a new log splitter with honda gcv 160la engine. it will start on a couple pulls at 70 degrees, at 50 degrees it takes 7 or 8 pulls, at 30 degrees it takes 30 pulls if it starts at all, below 30 forget about it, Any ideas will be appreciated. is this normal for a log splitter?, would...
  6. M

    gvc 160 honda wont start please help

    Hi All, i just bought a reconditioned log splitter with a honda gvc160 engine ohc model, , it started at the store after 6 or 8 pulls. not good but i fiqured we over choked or such. at home i could not start after 40 or so pulls, drained all gas , put in new gas, new plug, old plug was soaked...
  7. M

    Shout out to Zane Thank You

    Zane, Thank you for the help, I asked about hyd contol only lifting poorly or not at all at uppermost 1 " of quadrant, you told me to loosen four bolts on quadrant flange and knock it aft. I did and it works as good as new. I did knock it as far aft as it would go. what does that mean is there a...
  8. M

    ford 9n hyd loss

    My 9n with drop bucket has been working great every other day for about an hour each time. hyds have been fine. today they worked great for a while. I loaded up the bucket with firewood and bucket wouldn,t raise the same load it usually does. i backed up several feet and it raised fine got to...
  9. M

    installing thermostat

    i am going to put a 180 degree thermostat in my 9n, my question is, do I need to remove radiator to remove and reinstall upper hose??
  10. M

    9n shift boot

    okay, this is so dumb, but i can,t fiqure out how to install shift boot. help
  11. M

    9n shift boot install

    okay, this is so dumb, but i can,t fiqure out how to install shift boot. help
  12. M

    engine oil

    My question is. I recently bought a very good running 9n, Now I want to change engine oil and cannot get in touch with previos owner, so do I dare use detergent oil which could loosen a lot of crud if it has always used non detergent oil.any advice is appreciated
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top