Search results

  1. C

    farmall governor spring question

    Is this the spring I should be getting for my M and 400? I"ve read a lot on these forums about the 167 spring but have not had much success finding it...I think I have though in this link. I tried to reach out to ChadS, however, the number I saw in posts farther back doesn"t work. If anybody...
  2. C

    single acting cylinder help

    I"m probably just stupid asking this as I couldn"t figure out right away this afternoon but we just bought a new Bush hog for our farmall 400 and it has a single acting hydraulic cylinder on it. The cylinder had a number of spacers on it. We hooked it up and can tell the hose is moving from the...
  3. C

    tire pressure

    Fairly new to pulling. Have an M and 400 farmall that we took to a local pull a few weeks ago. Had a bit of a hard time "hooking up" to the ground and spun out a bit early. I"m thinking we had too much tire pressure but not sure if there is a general "sweet spot" tire pressure to start at and...
  4. C

    farmall m-450 hitch

    Not sure if original post made it but posting again...was curious if there is anybody out there fabricating hitches bolt-on for IHC tractors that would be adjustable for height etc...can't seem to find anybody out there and wanted to see if it is already available before going to a...
  5. C

    Farmall 400 Running Rough

    On very low idle, it seems to run quite smooth. When sitting but throttle opened-up...the motor runs extremely rough. When under load, however, it does even itself out a bit. I had the carb off and cleaned it up very well. No problems there. Getting fuel from the gas tank just fine as well...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top