(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. D

    Steel buildings,,, good or bad experiences

    I'm getting close to buying a prefab steel building and hoping I'm not making a mistake. There seems to be 100's of companies selling buildings, but most I figure are only brokers. This is a first time purchase for me and not sure I trust any of these companies. The best prices I have so far are...
  2. D

    Continental F series cylinder miss

    I'm working on an old Clark forklift with an F series Continental engine, it's either an F-140 or an F-162, but shouldn't make any difference. It sat for years and I got it running fairly easily, but I have a miss on #2 cylinder. I checked compression on all 4 cylinders with all the plugs...
  3. D

    Deere 1020 roosa pump no timing mark

    I started to remove the pump and can't find the timing mark on the rotating ring. I turned the engine over many times and no mark is visible. I read somewhere that the marks are etched? Could it be worn off, or if the pump was worked on before, could parts have been replaced and the mark was...
  4. D

    1020 starts then dies

    I have a 1020 I just bought, it wasn't running when I bought it, but it started easily after charging the battery and everything seemed fine. Today I ran it about 10 minutes to get it warm, then it started to slowly lose speed and die out. It will restart immediately, then run about 20 seconds...
  5. D

    Massey 2500 forklift transmission trouble

    I have a Massey 2500 forklift with the instant reverse transmission that just stopped moving. It was working fine and had lots of power in both directions. I was moving on the level with no load, went to change directions and it wouldn't go in either direction. Didn't hear any strange noises. I...
  6. D

    Massey instant reverse transmision won't move

    I have a Massey 2500 forklift with the instant reverse transmission that just stopped moving. It was working fine and had lots of power in both directions. I was moving on the level with no load, went to change directions and it wouldn't go in either direction. Didn't hear any strange noises. I...
  7. D

    Roosa Master injection pump problem

    I just bought an AC HD-4 with a Roosa Master DBGFC pump. The tractor has sat (inside) for 25 years. I got fuel flowing to the pump inlet, but no further. I took out the inlet regulating valve and also the transfer pump assy. All appears to look ok. I also removed the top cover on the pump and...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top