(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. T

    Mystery Piece

    What might this go to? (I do not know myself)
  2. T

    Carb Dust Seal, Which Direction

    Which way is in and which way is out? I was thinking that the open side should face out, and the flat side in, so that the vacuum from inside the carb could pull the seal tight around the shaft.
  3. T

    Estimated weight of liquid-ballasted tires...

    Planning to pick up an AC D19, but concerned that if the tires are filled it might put me over the weight limit for my transport trailer. Any estimates on how much weight ballasted tires might add?
  4. T

    What is the name for this implement?

    Does anyone know the name for this and has anyone used one before? I haven't tried it yet and don't know what it is called. [/img:90d029dcf3]
  5. T

    Differences Between NH 268 and NH 68 Balers

    Hello everyone, Does anyone know about differences between the NH 268 and NH 68 balers? I know that 68 is the older series, but is there a difference in HP requirement? I would expect the 268 is "improved" in some ways. Any specifics? Thank you in advance.
  6. T

    Discing with 8N

    I've been discing at a bit lower than full throttle. Can I just go to full throttle and pick an appropriate gear? Or is that to much to sustain? Things sound okay though when actively discing with full throttle, long as I back off throttle before putting the clutch in...
  7. T

    Best way to hook 8N to trailer

    Tips and Suggestions? Light and small, so minimal needed?
  8. T

    Best way to chain 8N to trailer

    Any tips and suggestions? Which points on the tractor front/rear should I use.?
  9. T

    pitman arm Blues!

    I'm in a pinch. I need to remove a pitman arm Again for a Second Time that I Already removed a few weeks ago. The trouble is, this time round has been way harder!. Lots of heat from torch, using same puller as last time, but no budging. Plenty of PB too... My current plan is to find a better...
  10. T

    power steering Converted to Manual Steering

    Has anyone done this on their tractor?
  11. T

    AC Model G air cleaner TUBE replacement

    Any suggestions for a substitute replacement for that metal tube running from carb to the air cleaner?
  12. T

    Model G Air Cleaner TUBE replacement

    Any suggestions for a substitute replacement for that metal tube running from carb to the air cleaner?
  13. T

    McCormick #56W Baler

    Any opinions or information out there on a McCormick #56W Baler?
  14. T

    McCormick #56W Baler

    Any opinions or information out there on a McCormick #56W baler?
  15. T

    Sector Shaft Reinstallation

    Feels like a dumb problem to ask about, but having a lot of trouble getting a sector shaft (item #11) reinstalled in a power steering gear box. Got it lined up and most of the way in (gears were meshed properly) but can't seem to make it move the last couple of inches forward. Been tapping...
  16. T

    How about motor oil in an old transmission?

    1949 AC Model G needs transmission/hydraulic oil changed. Manual specifies straight 20W for this system. I know the need to avoid conventional hydraulic and transmission oils because of their Brass-Coroding Factors. Any opinions on using readily available 20W-50 motor oil as substitute?
  17. T

    Outer Seal Problem (Steering Box)

    My parts diagram and shop manual seem to be incomplete. It appears that #14 outside neoprene u-seal (see image) - which I scraped off - was actually one unit with an outer metal casing. The casing/u-seal unit looks like it was hammer fitted into the greater steering gearbox housing. You...
  18. T

    Needle Bearing Removal

    Trying to get circled needle bearing out of steering gear box housing without damaging it. Any tips?
  19. T

    Transmission Flush AC G

    What exactly does my operator manual mean when it says to "flush" the transmission after draining before refilling? Merry Christmas!
  20. T

    6V Starter Rebuild

    Just pulled out the starter on a 1949 AC Model G. Any tips for a newbie on how to clean up the inside and which parts to check or replace?
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top