(800) 853-2651
SHOP NOW

Search results

  1. P

    core plug or expansion plug?

    concave on one side convex on the other with DORMAN PRODUCTS and F32S, new one just says dorman and a new number. The concave side goes toward the camshaft and sits inside the lip or recessed..I can place it in the hole and pull it back out using heavy duty tape. Yes the old one was cracked I...
  2. P

    second governor blown apart

    The same D-17 engine and unit as my previous post. Am installing the second governor in this engine because it seems the weights pins and clips just blow right off. The gear is totally torn apart at the weight attachment point and I also have to replace the cam gear. I noticed on Combine D-17...
  3. P

    core plug or expansion plug?

    thanks i appreciate your quick reply
  4. P

    core plug or expansion plug?

    the camshaft plug at the rear of D-17 engine on my AC Model D motor grader was cracked and leaking oil bad! had a heck of a time taking it out and now installing the new one. Do you hit it pretty hard to set it in? seems like that is why the first one was cracked. do you need or should you put...
  5. P

    My new AC

    Just purchased one for my B. NO MANUAL! Can you please send me photos on how its mounted and the pulley setup. *I also cant figure out how to mount the hydraulic lift cylinder. Thank you very much for any help.:)
  6. P

    Allis # 5 Mower for a CA

    give me a call ok. 505-470-4638
  7. P

    AC B weights

    Frank in AZ has 3 model B's for parts (2 resleaved engnes) for sale contact him for more info
  8. P

    DD motor grader shift pattern

    here you are D and the DD have the same trany. the R position for the reverse goes toward the rear or the engine the 1 & 2 go to the front any other questions free to call 505-470-4638
  9. P

    D-17 power steering

    My D-17 Series 1 also does not work. filled it up and ran unit, it would not steer to one side. stopped and cked the oil level and it again was low. Then for some reason I checked the engine oil and it was way over filled. So I drained the engine oil and some of the PS oil and left it alone...
  10. P

    John Deere 310C backhoe diesels when ignition turned off

    Well, check the timing and carberator may be too rich and is feeding fuel when it is shut off and being sucked into the hot engine. I dont know about the engine swap, but I do know that I have a 310B right on the frame of the unit and it also has a gasoline engine. Is is possible these two...
  11. P

    TD 340 cranks slow?

    Yup you were right about the jumper cables. paid over $40.00 for the size 1 battery cables and then connected an extra battery to it. placed a jump starter battery to the glow plug wires and it cranked over good and did start. It will however not start again if it dies out, just have to wait it...
  12. P

    TD 340 cranks slow?

    Been trying to start this TD 340 crawler. Had started it a while ago and got it on and off a trailer. Now I cant start it. I have a new battery but cranks very slow. I took out the injectors and fuel does squirt out the holes and engine turns over pretty good. when even one injector is in it is...
  13. P

    What Model is this IH Drill?

    Owner trying to sell this IH Drill. We cant seem to find a data plate on it. Everything looks like very little use, just needs some paint nothing broken looks great, works great. No data plate, unknown model, no book/manual. Does anyone know? What should he try to sell it for?
  14. P

    AC H-3 Goes in Reverse only

    Well, I went to see the old gentleman who owns this unit (25 yrs). Asked him for the whole story. He had the engine rebuilt 5 yrs or so ago. He said he was using it all the time, as of late he had to hold the shuttle clutch handle on the leftside (Hi/Lo Power Director on tractors on...
  15. P

    AC H-3 Goes in Reverse only

    H-3 drives in reverse only. Last time used was operating fine. Not used in over a year, Now it will only move in reverse. Someone said the clutches needed to be shimmed? After some tinkering it did move a bit forward. Someone else said it needed the clutches replaced? Someone said it was the...
  16. P

    AC H-3 Goes in Reverse only

    H-3 drives in reverse only. Last time used was operating fine. Not used in over a year, Now it will only move in reverse. Someone said the clutches needed to be shimmed? Someone else said it needed the clutches replaced? Someone said it was the manual transmission? Do not know. Some...
  17. P

    IH T-340 Questions

    Hello there jaluhn! Got all the filters I could from NAPA. Call me so we can talk K. 505- 470-4638. Talk to you soon.
  18. P

    D17 rough running

    My Model D grader (same D-17 engine) did the same thing then would not start my brother spent all day trying to figure it out. I replaced the coil and it started right up. My D-17 does that also once in a while and I just clean the bowl and ck for good fuel flow then I pull out the Power jet...
  19. P

    Ford 8 or 9N with ditcher

    Anyone need a ditcher with an 8 or 9n attached? It is in AZtec New Mexico will attach the photo. Is on Craigslist, Albuquerque, for sale, tractor. Just posting it if anyone interested. they want 2300 for it. ph 5zero5 33zero 3466
  20. P

    TD 340 track guage template

    I"ve wanted to check the tolerances on my TD 340 track, pins, grousers etc.. I noticed in the service manual they showed using a track guage/template to check all the tolerances. I read somewhere that mentioned they made one by the book but I cant find it (in the service, parts or operators...
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top