-
F
Ford 800 running rough and fouling plugs
This message is a reply to an archived post by Tim PloughNman Daley on January 13, 2023 at 02:04:29. The original subject was Re: Ford 800 running rough and fouling plugs. Unfortunately I did I will try a new high performance coil from YT, and maybe the electronic ignition set. -
F
which coil and ignition upgrades
I have had enough with playing with my 800. It ran well for 12 years, then I ran out of gas and it went down hill from there. The reasons may be plentiful for such a simple system, trouble nonetheless. I changed the oil, coil(3x the first was bad 2nd worked for a while), spark plugs, points... -
F
Ford 800 running rough and fouling plugs
I have a Ford 800 and I am having an issue with it running rough and stalling, and fouling the plugs. I replaced the coil ,plugs and rebuilt the carb last fall. The tractor ran well but the next time I started it the problems began. I did forget to shut the gas off. The oil now looks dark and... -
F
Low power in a ford 800
I checked everything as I said in my last post. It turned out to be a bad new coil. Everything is running ok but it does not seem to have the same power when I cut tall grass with my brush hog. I cleaned the carbon off of the plugs but I need check them again. I have difficulty checking the... -
F
Stalling ford 800
I am going crazy with my Ford 800. It was running great until I got some bad gas. I drained the carb. and added new fuel. That's when the trouble began, it would not run and started to stall when it had a load. I rebuilt the carb, put in a new coil, plugs, points and condenser. It is doing the... -
F
I need help with hydraulic seal repair
My Ford 800 is leaking very badly from the joint between the transmission and the rear end. I probably will have to split the tractor to repair this. How is this done and is it difficult. Nick- Fiatmom
- Thread
- Replies: 0
- Forum: Restoration Processes
-
F
Ford 8N 3pt hitch not raising
I am having a recurrent problem with my Ford 8N. For some reason the 3 point hitch will not raise. There seems to be no reason for this behavior. I power washed it today to get all of the grease and mud off of it. Everything seemed to operate well before but would not operate afterwards. I also... -
F
8N steering
Is there a way to make steering easier on my 8N? By the end of the day I'm beat. An even worse problem is maneuvering around obstacles. There have been times I could not turn well enough to avoid rocks ect.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy