(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. T

    Gravity wagon to running gear attachment

    Correction. About 1/2 of the wood from the bottom.
  2. T

    Gravity wagon to running gear attachment

    Picked up a fairly new Unverferth 235 gravity box with 10 ton running gear. It had been bolted on all 4 corners but whoever did it drilled on an angle so the bolts came out close to the bottom. All 4 corners have the wood split near the bottom. About 1/2 of the wood split. There are also...
  3. T

    4240 Load Control shaft leaking

    Good advice below. We did a 4240 a few years back. We also used the old load shaft to remove the seals and bushings. We used 2 people to ensure hitting the proper place. There is a hole in the rim you need to line up with the load shaft to allow for it to be removed. We replaced all...
  4. T

    Pro's & Cons TeeJet Matrix 430 or Raven CruizerII GPS u

    We have 2 cruizer 2 units. They have been solid. Just ordered the autosteer to add to the spraying tractor. For smaller operators they are nice. They don t have all the bells and whistles but also don t cost as much. No experience with the tee jet unit.
  5. T

    Soybean head reel wont turn

    If it is hooked to a 20 series combine it may be the belt slipping on the reel hydraulic pump. The reel has its own pump located on the cab side towards the rear. This has happened to us before.
  6. T

    John Deere 4440 wire colors

    Most are multi connectors. The individual ones at the starting solenoid are a concern. Also concerned about trouble shooting in the future. We haven’t installed it yet so not sure if it works.
  7. T

    John Deere 4440 wire colors

    Appears service manual TM4346 and TM1182 have different information.
  8. T

    John Deere 4440 wire colors

    Trying to replace the front wire harness for a John Deere 4440. I have the service manual with the wire diagram as colors and numbers. I ordered a replacement harness from wiring harness.com. It was supposed to be the same colors. Nothing matches what I have on the tractor or manual. My...
  9. T

    Overcharging batteries 4440

    Looking at replacing the wire harness. Anyone do this lately or have opinions on the harnesses at http://www.wiringharnesses.com/files/129876509.pdf
  10. T

    Overcharging batteries 4440

    Well, did some digging and found the wires 1 and 2 from the alternator in poor shape. The wire insulation is brittle and broken and the copper wire just falls apart.
  11. T

    Overcharging batteries 4440

    4440 voltage meter is in the orange high side. Checked and batteries reading 16.6 volts running. What causes this? Thanks
  12. T

    40 series cab inside rearview mirror

    Thanks. This is what came up.
  13. T

    40 series cab inside rearview mirror

    Old topic Picked up a 4440 and went to buy an inside mirror for it same as the other and now the mirror is no longer available but the bracket is. Anyone have a good condition mirror they want to part with or know of a substitute? Thanks Tim
  14. T

    Removing muffler 4440

    Any advice for removing a stuck muffler on a 1982 4440? Removed the clamp and soaked with penetrating oil. No go.
  15. T

    Hardi sprayer connector

    Would like to replace this connector as it is broken. It is from a Hardi sprayer. Any idea what kind of connector this is?
  16. T

    Adding fertilizer to Kinze 3500

    Anyone add fertilizer to Kinze 3500? Looking at planters with inter plants and most don’t have the fertilizer option.
  17. T

    Striped corn field

    What makes a corn field look striped from the air? Noticed some look this way and some not.
  18. T

    Case backhoe bucket pin sizes

    Case 580 super K. Went to switch buckets from 24 to 12 for the first time yesterday and pins didn't fit the smaller bucket. Spacing was correct. Is this bucket for another 580 series or are different pins/bushings required.
  19. T

    4640 Front End Weights Installation

    As long as you have full nut thread engagement your good. Lock washers not needed if bolts have enough stretch length and torqued properly. Dad lost a set of weights on a 4020 going down the road once. Fun.
  20. T

    Always Kinda Liked This Style Truck

    Ask for the build sheet. I have a 1978 2100A. Without the build sheet don't now what you have. I also bought the parts and service manual which help out.
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top